Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
Search Results "Counter Length"
-
11B-810.2.2 Dimensions
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
Refuge Islands
"(29) However, recumbent bicycles, bicycles with trailers, and hand cycles all have 85th percentile lengths greater than 1.8 m (6 ft)....
-
1003.2.1 Boat Slips
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....
-
1003.2.1 Boat Slips
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....
-
1003.2.1 Boat Slips
Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with 1003.2 unless required by 202.4....
-
Slopes and Resting Intervals for Beach Access Routes
Sections of beach access route of any length are allowed to have a running slope ratio of up to 1:20 (5 percent grade) (see figure 37)....
-
11B-1003.2.1 Boat slips
Exceptions: Where an existing gangway or series of gangways is replaced or altered, an increase in the length of the gangway shall not be required to comply with Section 11B-1003.2...
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
Landings
Must be as wide as the ramp they connect to A minimum length of 60 inches (1525 mm) If ramps change direction, the minimum landing size must be 60 inches (1525 mm) wide...
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
407.12.3.1 Unobstructed Forward Reach
Where the operable part is located at the leading edge of the maximum protrusion within the length of the vertical reference plane of the ICT, the operable part shall be 48 inches (1220...
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
226 Dining Surfaces and Work Surfaces
surfaces covered do not include those surfaces used by employees, since elements of work stations are not required to comply with these guidelines (226.1) exempt sales and service counters...
-
D. Reach Range
[ADA Stds. 5.5] Yes __ No __ N/A __ Comments: ________________________________________ ...operational controls higher than 46" if they are set back 10"-24" from the edge of the counter...
-
Single-User Toilet Rooms: No Side Transfer Space
Lavatory placement is limited by the rear gab bar, which should not overlap counter surfaces....
-
FBD Partnership Two Flavors Frozen Beverage Dispenser
RapidFreeze™ Cold Chamber system improves recovery and draw-time, while reducing compressor run-time Electronic Simplicity offers easy-to-use keypad interface Optimal Use of Counter...
-
FBD Partnership Three Flavors Frozen Beverage Dispenser
RapidFreeze™ Cold Chamber system improves recovery and draw-time, while reducing compressor run-time Electronic Simplicity offers easy-to-use keypad interface Optimal Use of Counter...
-
1.1.11 Ramp running slope
overall running slope of ramps by determining elevations at the top and bottom of the ramp at the midpoint of the width of each ramp run and calculate the slope using the horizontal ramp length...
-
Single riser stair handrail extension
For a stair with one riser only, what is the length of the bottom handrail exension required?...
-
Alterations
Examples include restriping a parking lot, moving walls, moving a fixed ATM to another location, installing a new sales counter or display shelves, changing a doorway entrance, replacing...
-
Observations:
It would be very difficult for the occupant to have the powered device come to rest on a platform that is the exact length as its wheelbase or even a few inches more....
-
505.3 Continuity
Handrails shall be continuous within the full length of each stair flight or ramp run....
-
Running Slope (Grade)
The ascent or descent of a trail segment expressed as a percentage of its length, which is the difference in elevation of a section of a trail measured parallel to the predominant direction...
