A clear maneuvering space at least 30 inches in width by 48 inches in length (762 mm by 1219 mm) shall be located outside the shower, flush and parallel to the control wall....
Search Results "Counter Length"
-
1134A.6, Item 3
-
General Tips
If service counters are too high for some users, such as people of short stature and people using wheelchairs, step around counters to provide service....
-
Kompan, Inc. M243 - Crocodile Bench
Small builders will gather and explore loose materials on the counters....
-
§8.3 Adaptability
Adaptability means the ability of certain elements of a dwelling unit, such as kitchen counters, sinks, and grab bars, to be added to, raised, lowered, or otherwise altered, to accommodate...
-
III-7.8200 Restaurants and cafeterias
ADAAG contains requirements for counters and bars, access aisles, food service lines, tableware and condiment areas, raised speaker's platforms, and vending machine areas (but not controls...
-
2013 & 2016 CBC Answer
Measurement Y1 through Y3 are irrelevant because the code does not require marking to define the "length" of parking per Section 11B-502.2. ...
-
5.4.9 Interruptions Along Transfer Support Gripping for Equipment Used in a Supine, Prone, Side-Lying, or Seated Position
The bottom of the transfer support shall have no obstruction affecting more than 20% of its length....
-
R409.3 Continuity
Handrails shall be continuous within the full length of each ramp run or stair flight....
-
Can guards or collars be attached to handrails to prevent skateboard traffic?
surfaces at egress stairs subject to the Standards must be unobstructed on the top and sides and free of sharp or abrasive elements so that users can maintain a continuous grip along the full length...
-
E1-a
Is there an accessible route, at least 36 inches wide, that connects the accessible entrance to all shelter areas (it may narrow to 32 inches wide for up to 2 feet in length)?...
-
§ 37.131(c)(1)
(1) In calculating the full fare that would be paid by an individual using the fixed route system, the entity may include transfer and premium charges applicable to a trip of similar length...
-
Caroma® USA Invisi Series II Cube Wall Hung Water Closet
Cube InvisiTM II dual flush high efficiency toilet (HET) is suitable for inwall, induct, inceiling and under counter applications....
-
Caroma® USA Invisi Series II Walvit Wall Hung Elongated Water Closet
Walvit Wall Hung Elongated InvisiTM II dual flush high efficiency toilet (HET) is suitable for inwall, induct, inceiling and under counter applications....
-
Gift Shops
Hand credit cards back to your guest, rather than leaving them on a counter....
-
5.4.5 Transfer Support Position Recommendation for M301 and M302
This provision would apply along the support length and not to the cross-sectional profile of the gripping surface, see Figure 5.4.1.1....
-
Ramp
The minimum length was 8 inches and the maximum length was 11 inches....
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
§ 38.23(d)(4) Orientation
In vehicles in excess of 22 feet in length, at least one securement device or system required by paragraph (a) of this section shall secure the wheelchair or mobility aid facing toward the...
-
11B-607.2 Clearance
Clearance in front of bathtubs shall extend the length of the bathtub and shall be 48 inches (1219 mm) wide minimum for forward approach and 30 inches (762 mm) wide minimum for parallel...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
Step 3: Apply the Accessibility Provisions
If the grade requirement can't be met because of a condition for an exception, measure and record the length of trail that will deviate from the technical requirement....
-
1.1.13 Flatness of ramp running slope
Measure flatness in the running slope of ramps at 12 - in. (300 mm) increments by using successive, overlapping 24 - in. (600 mm) lengths using a 24 - in. digital inclinometer....
