[DSA-AC] An auditorium, convention center, cultural complex, exhibition hall, permanent amusement park, sports arena, theater or movie house for which the maximum occupancy is 2,500 or more...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
COMMERCIAL PLACE OF PUBLIC AMUSEMENT
-
11B-605.4 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except that the flush control shall be mounted at a maximum height of 44 inches (1118 mm) above the finish floor....
-
1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (865 mm) maximum above the ground or deck surface....
-
1009.5.4 Transfer Steps
Transfer step height shall be 8 inches (205 mm) maximum....
-
608.3.3 Alternate Roll-In Type Shower Compartments
Grab bars shall be installed 6 inches (150 mm) maximum from adjacent walls. Figure 608.3.3 Grab Bars for Alternate Roll-In Type Showers...
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum...
-
403.5.1 Clear Width
EXCEPTION: The clear width shall be permitted to be reduced to 32 inches (815 mm) minimum for a length of 24 inches (610 mm) maximum provided that reduced width segments are separated by...
- ACO Premium Linear QuARTz Drain
- Inpro Corporation ENDURANT® Ceiling Hung Partitions
- Inpro Corporation ENDURANT® Floor-Mounted Overhead-Braced Partitions
-
Data Analysis
The 5th, 25th, 50th, 75th, and 95th percentiles were recorded along with the minimum and maximum heights attained for each part of each protocol....
-
7.4.3.1 Running Slope (Grade)
Where the running slope (grade) of a segment of a trail is steeper than 1:20 (5 percent), the maximum length of the segment shall be in accordance with Table 7.4.3.1, and a resting interval...
-
Common Requirements (R304.5) (Section-by-Section Analysis)
A maximum cross slope of 2 percent is specified for curb ramps, blended transitions, and turning spaces....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. Advisory 11B-809.2.2 Turning space....
-
11B-809.2.2 Turning space
Exception: Turning space shall not be required in exterior spaces 30 inches (762 mm) maximum in depth or width. Advisory 11B-809.2.2 Turning space....
-
11B-604.6 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except they shall be located 44 inches (1118 mm) maximum above the floor....
-
11B-604.6 Flush controls
Hand operated flush controls shall comply with Section 11B-309 except they shall be located 44 inches (1118 mm) maximum above the floor....
-
11B-404.2.7 Door and gate hardware
Operable parts of such hardware shall be 34 inches (864 mm) minimum and 44 inches (1118 mm) maximum above the finish floor or ground....
-
11B-404.2.7 Door and gate hardware
Operable parts of such hardware shall be 34 inches (864 mm) minimum and 44 inches (1118 mm) maximum above the finish floor or ground....
- Cornell University Employment And Disability Institute
- LaCantina Aluminum Thermally Controlled Slider System
- LaCantina Multi-slide Thermally Controlled Aluminum Sliding Door System
-
703.2.5 Character Height
Character height measured vertically from the baseline of the character shall be 5/8 inch (16 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter "I"....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level,...