Entities should consider providing either a 60 inches (1525 mm) minimum clear tread width or passing spaces at shorter intervals if the clear tread width is less than 60 inches (1525 mm)...
Search Results "Minimum Dimension"
-
1017.4 Passing Spaces
-
11B-604 Water closets and toilet compartments
INTERPRETATION Showers are fixtures including a 30 inch x 60 inch clear receptor with a minimum/maximum slope of ¼ inch per foot to a drain (refer to CPC Section 408.5 and CBC Section...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
Ramps with drop offs ½ inch or greater shall provide edge protection 2 inches high minimum on each side....
-
Seat Heights
No minimum height for steps is specified. Based on earlier findings (Phase 1 Final Report), there was concern that the 8 inch maximum may not accommodate some wheelchair users. ...
-
Protocol B Heights Obtained
Again for the minimum height protocol HERL participants transferred lower on average than the NDVWSC participants....
-
711.3.1 Through penetrations
used to fill the annular space shall prevent the passage of flame and hot gases sufficient to ignite cotton waste where subjected to ASTM E 119 time temperature fire conditions under a minimum...
-
In-swinging Bathroom Doors
Once a minimum door width is provided, a tenant who finds a bathroom not readily usable can have the door rehung as an outswinging door....
-
Rough Grade Site Inspection
Site Lighting shall be capable of providing a minimum of one foot candle to the surface. 1006...
-
Handrails [4.8.5]
The height of a guardrail (to prevent falling off the edge) is not specified by ADAAG; local building codes do, however, commonly regulate the minimum height of a guardrail at 42 inches....
-
Rough Grade Site Inspection
Verify if under-slab plumbing will provide adequate clearances from finished walls. 11B-604.2 Site Lighting shall be capable of providing a minimum...
-
II. REMEDIAL ACTION
Isolated or temporary interruptions in service due to maintenance or repairs are permissible, but Lewisboro agrees to keep these to a minimum. See 28 C.F.R. § 35.133. ...
-
1017.4 Passing Spaces
Entities should consider providing either a 60 inches (1525 mm) minimum clear tread width or passing spaces at shorter intervals if the clear tread width is less than 60 inches (1525 mm)...
-
608.6 Shower Spray Unit and Water
A shower spray unit with a hose 59 inches (1500 mm) long minimum that can be used both as a fixed-position shower head and as a hand-held shower shall be provided....
-
2.2.4 Maneuverability
Widths of the restricted space were set at a minimum of 750 mm (30 in.) for the 90-degree turn, 750 mm (30 in.) passage width for the U-turn with a barrier, and 1300 mm (51 in.) for the...
-
10 - foot straightedge method
When the 10 - foot straightedge method is used for random traffic floors, ACI 117 sets the minimum number of samples required at 0.01 times the floor area, measured in square feet....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Geometric symbols at entrances to toilet and bathing rooms shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured...
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
1009.7.2 Separation
Exterior walls separating the exterior area of assisted rescue from the interior of the building shall have a minimum fire-resistance rating of 1 hour, rated for exposure to fire from the...
-
11B-608.5.2 Standard roll-in type shower compartments
standard roll-in type shower compartments, the controls, faucets, and the shower spray unit shall be located on the back wall of the compartment adjacent to the seat 16 inches (406 mm) minimum...
-
608.6 Shower Spray Unit and Water
A shower spray unit with a hose 59 inches (1500 mm) long minimum that can be used both as a fixed-position shower head and as a hand-held shower shall be provided....
-
Shelves and Maneuvering Space
Provide a 36" minimum width route between displays and shelves if readily achievable Notes on photo: Sales items may be located at any height but sales staff should be available...
-
Scoping
The minimum number of guest rooms required to be accessible in transient lodging facilities is covered by section 224 of the 2010 Standards....
-
Sample Size Estimation
Data from the maximum and minimum height transfers from protocol A were used for this analysis....