Types of Alternative Designs All of the participants responded that their firms had designed facilities that incorporated bathroom designs that deviated from, or went beyond the minimum...
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
Types of Alternative Designs
-
4.1.1(5)
both, then accessible spaces, complying with 4.6, shall be provided in each such parking area in conformance with the following table: Total Parking in Lot Required Minimum...
-
11B-221.3 Companion seats
When designing, best practice is to locate wheelchair spaces in rows where seating for a minimum of four is provided....
-
11B-221.3 Companion seats
When designing, best practice is to locate wheelchair spaces in rows where seating for a minimum of four is provided....
-
11B-805.7 Built-in cabinets and work surfaces
Clinical laboratory work stations provided in a laboratory area that are in addition to the minimum number required to be accessible (5 percent of the work stations provided, but no fewer...
-
11B-213.3.1 Toilet compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment. ◼ ETA Editor's Note With the...
-
11B-208.3.1 General
The minimum number of spaces must still be determined separately for each facility even if the spaces are to be provided in other facilities or locations....
-
EXHIBIT A Required Accessible Elements at QuikTrip Stores
All objects that protrude from surfaces or posts into circulation paths shall comply with ADA Standards § 4.4 and a minimum 80 inch vertical clearance shall be provided in walks, halls,...
-
ADA25: #5 of 25 -- Title III
Unlike Title I for employment, which covers only entities with 15 or more employees, Title III does not have a minimum number of employees requirement....
-
Rulemaking History
ABA Accessibility Guidelines The Board issued minimum guidelines for federally funded facilities under the ABA in 1982....
-
II. COMPLIANCE WITH TITLE III OF THE ADA
Phase I: By January 1, 2015, H&R Block shall ensure that www.hrblock.com and the Online Tax Preparation Product conform to, at minimum, the Web Content Accessibility Guidelines 2.0 Level...
-
Americans with Disabilities Act
4Subtitle A of Title II of the Americans with Disabilities Act requires that the regulations issued by the Department of Justice include accessibility standards that are “consistent with the minimum...
-
INTRODUCTION
A 1978 amendment to Section 502 of the Rehabilitation Act added to the ATBCB's functions the responsibility to issue minimum guidelines (Guidelines) and requirements for the standards established...
-
201.1.1 Vertical accessibility
Buildings, structures and facilities must, at a minimum, comply with the requirements of the ADA Standards for Accessible Design. Advisory 201.1 Scope....
-
11B-216.13.3 Conditions of use
These pest control practices shall not be used 48 hours prior to placement of the sign, and the facility shall be ventilated with outside air for a minimum of 24 hours following use or application...
-
Issue 3: Which signal? Speech WALK messages necessary
In Figure 6, it appears that the required APS separation (10 feet minimum) could have been achieved here by locating stub poles to the left side of the left ramp and the right side of the...
-
Location
Devices must be located a minimum of 3m (10 feet) apart, no more than 3m (10 feet) maximum from the curb line (and closer, if possible), and between the curb ramp landing and the outside...
-
F233.1 General
Section F233 is not a stand-alone section; this section only addresses the minimum number of residential dwelling units within a facility required to comply with Chapter 8....
-
SENSORY PROVISIONS
For transmitted voice signals, provide a gain adjustable up to a minimum of 20 dB gain. For incremental volume control, provide at least one intermediate step of 12 dB of gain....
-
Picnic Tables [1011.2 and 1011.4]
At least one wheelchair seating space a minimum of 30 by 48 inches must be provided for each 24 linear feet of usable space around the perimeter of a tabletop....
-
Executive Summary
However, Committee members failed to agree upon the recommended lowest or minimum height for adjustable-height transfer surfaces....
-
407.12 Reach Height (Section-by-Section Analysis)
This section proposes maximum and minimum reach heights for either forward (over the lap) or side reaches to stationary ICT....
-
2.2.2.2 New York State Standards
The minimum sensitivity of the receiver shall be no greater than 1 uV at 12 dB SINAD....
-
7. INSTALLATION
While the different ALS and venues will require different depths and ranges of competencies, all require some minimum of information if the system is to be installed correctly....