At least one door at the accessible entrance must have a minimum clear width of 32 inches for a voter who uses a wheelchair or other mobility device to pass through the doorway....
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
Building Entrance
-
11B-705.1.2.2 Curb ramps
Detectable warnings shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the line at the face of the curb marking the transition...
-
Revolving Doors or Turnstiles
While automated revolving doors, if large enough, may be usable by people with disabilities, certain questions remain about the appropriate maximum speed, minimum diameter, compartment size...
-
Team Player Seating Areas
If designers and operators are designing a field or court that will serve a variety of wheelchair sports, exceeding the minimum requirements will better accommodate participants....
-
Sloped Entries
Sloped Entries Sloped entries must comply with ADAAG accessible route provisions (36 inch minimum width, maximum 1:12 or 8.33% slope), except that the surface does not need to be slip...
-
F235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory F235.2.1 Dispersion....
-
F221.4 Designated Aisle Seats
Only when all seats on Aisle A would not meet the five percent minimum would seats on Aisle B be designated....
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2....
-
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis)
The access aisle must be 1.5 meters (5 feet) wide minimum and connect to a pedestrian access route....
-
235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory 235.2.1 Dispersion....
-
307.2 Protrusion Limits
For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
-
221.4 Designated Aisle Seats
Only when all seats on Aisle A would not meet the five percent minimum would seats on Aisle B be designated....
-
Facility
The tops of dining surfaces and work surfaces shall be 28 inches minimum and 34 inches maximum above the finish floor or ground....
-
T702.4 Character Height
Table T702.4—Character Height Sign location Minimum character height Exterior route or destination signs on boarding side of non-rail...
-
Ramp
The minimum length was 8 inches and the maximum length was 11 inches....
-
Is a transportation operator required to carry these “overweight” wheelchairs?
If a lift has the minimum design load of 600 pounds, there is no requirement for an agency to transport a heavier occupied device....
-
235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory 235.2.1 Dispersion....
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
A4.5.3 Carpet
When both carpet and padding are used, it is desirable to have minimum movement (preferably none) between the floor and the pad and the pad and the carpet which would allow the carpet to...
-
Obstructions [4.7.8]
A landing with a minimum length of 48 inches will provide sufficient turning space....
-
Grab Bars [4.20.4] and Controls [4.20.5]
Recommendation: A hose for shower spray units longer than the required minimum of 60 inches is recommended for easier use of the shower spray unit from the seat....