Flange will adjust from a 1" minimum to a 6" maximum wall depth....
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
AJW Architectural Products U526 Series U526-10 Sanitary Napkin/Tampon Dispenser - 10 cent Operation - Recessed
-
Accessible Mats for Beach and Outdoor Events
Lightweight and durable 36” x 36” portable mats that only weight 5.2lbs each Exceed the minimum ADA and ABA width requirement for a beach access route with double-wide configurations...
-
Panda S.85 All Aluminum Slim Profile Lift and Slide System
Systems can pocket to left or right, and can stack to left and/or right. 45 and 90 degree configurations are available, as well as panoramic with a radius of minimum 144"....
-
11B-233.3.1.2.6.3 Test number two, site analysis test
The minimum percentage of ground floor units required on an accessible route shall equal the percentage of the total buildable area (not restricted-use areas, flood plains or wetlands) of...
-
11B-706.1 General
The technical standards for assistive listening systems describe minimum performance levels for volume, interference, and distortion....
-
11B-606.2 Clear floor space
A knee clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or...
-
11B-233.3.4.2 Alterations to individual residential dwelling units
other room is altered, the requirements of Section 11B-233.3.1 shall apply to the altered residential dwelling units until the total number of residential dwelling units complies with the minimum...
-
4.3.4 Industry Considerations in Designing Accessible Imaging Equipment
Today, it does not appear that any diagnostic imaging systems meet a minimum transfer height of 17” (see Sections 5 and 7)....
-
Station 3-Turning Radii
For bicycles, AASHTO (p. 38) recommends a minimum radius of 12 m (36 ft) for a design speed of 20 km/h (12 mi/h), increasing to a minimum radius of 74 m (225 ft) for a design speed of 50...
-
Installation of Aggregate Surfaces at Bradford Woods
100 No. 4 30‒60 35‒55 No. 30 5‒35 10‒30 No. 200 0‒12 2‒9 The crushed rock shall be applied to the trail bed at a minimum...
-
Opening Force [§404.2.9]
Opening Force [§404.2.9] The maximum 5 lbf opening force applies to all accessible doors and gates except: fire doors (minimum opening force allowed by code) exterior...
-
11B-233.3.4.2 Alterations to individual residential dwelling units
other room is altered, the requirements of Section 11B-233.3.1 shall apply to the altered residential dwelling units until the total number of residential dwelling units complies with the minimum...
-
11B-703.7.2.5 Cleaner Air Symbol
The symbol, which shall include the text “Cleaner Air” as shown, shall be displayed either as a negative or positive image within a square that is a minimum of 6 inches (152 mm) on each...
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....
-
Building Entrance
At least one door at the accessible entrance must have a minimum clear width of 32 inches for a voter who uses a wheelchair or other mobility device to pass through the doorway....
-
11B-705.1.2.2 Curb ramps
Detectable warnings shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the line at the face of the curb marking the transition...
-
Revolving Doors or Turnstiles
While automated revolving doors, if large enough, may be usable by people with disabilities, certain questions remain about the appropriate maximum speed, minimum diameter, compartment size...
-
Team Player Seating Areas
If designers and operators are designing a field or court that will serve a variety of wheelchair sports, exceeding the minimum requirements will better accommodate participants....
-
Sloped Entries
Sloped Entries Sloped entries must comply with ADAAG accessible route provisions (36 inch minimum width, maximum 1:12 or 8.33% slope), except that the surface does not need to be slip...
-
F235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory F235.2.1 Dispersion....
-
F221.4 Designated Aisle Seats
Only when all seats on Aisle A would not meet the five percent minimum would seats on Aisle B be designated....
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2....
-
Parallel Parking Spaces (R309.2) (Section-by-Section Analysis)
The access aisle must be 1.5 meters (5 feet) wide minimum and connect to a pedestrian access route....
-
235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory 235.2.1 Dispersion....
