(6) At the primary entry door to dwelling units with direct exterior access, outside landing surfaces constructed of impervious materials such as concrete, brick or flagstone, are no more...
Search Results "Check Writing Surface"
-
4(6)
-
Story
That portion of a building included between the upper surface of a floor and upper surface of the floor or roof next above....
-
382.133 What are the requirements concerning the evaluation and use of passenger-owned electronic devices that assist passengers with respiration in the cabin during flight and do not contain hazardous materials?
for carrying such a device on board, touching on such matters as meeting FAA requirements, having the manufacturer’s label, bringing an adequate number of fully charged batteries, any check-in...
-
ADA Fast Finder
mobile ready Unlimited searches Standard Search: FREE (Sign up required) Search all Federal Standards Add an additional State Standard Cross Check...
-
3. Medical Diagnostic Equipment
rulemaking (NPRM) to remove the sunset provisions in the our existing accessibility standards for medical diagnostic equipment (MDE) related to the low-height specifications for transfer surfaces...
-
Location and Size
The side rails are 20 inches minimum in length, 6 inches minimum in height above the table surface, and 1 inch measured horizontally from the adjacent edge of the table surface....
-
3. Scope—Web Sites and Other Electronic Information and Communication Technologies
The Department asked for comment on whether we should limit the requirement to certain portions of the primary Web site (e.g., booking function, checking flight status), whether the requirements...
-
Ensure that communication with people with disabilities is as effective as communication with people without disabilities
facilitated compliance with this obligation: Trained staff and officers to use effective communication methods, such as using simple language to convey an oath or question, checking...
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
-
2.3.2
For example, floor profilers can provide a very accurate measurement of surface flatness but are expensive and require training to use....
-
11B-705.3 Product Approval
Only approved DSA-AC detectable warning products and directional surfaces shall be installed as provided in the California Code of Regulations (CCR), Title 24, Part 1, Chapter 5, Articles...
-
Foot-candle
The illumination on a surface one square foot in area on which there is a uniformly distributed flux of one lumen, or the illuminance produced on a surface all points of which are at a distance...
-
Seat Height
Commenters noted that this specification should be clarified as applying to the height as measured at the top of the seat surface. Response....
-
R405.3.3 Minimum Required Depth
Where knee clearance is required under an element as part of a clear space, the knee clearance shall be 280 mm (11 in) deep minimum at 230 mm (9 in) above the finish surface, and 205 mm...
-
1132A.4 Level floor or landing
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
-
E. IMPLEMENTATION AND ENFORCEMENT
If the United States believes that the Museum is not in compliance with this Agreement or any requirements contained herein, the United States agrees to notify the Museum in writing of the...
-
1132A.4 Level floor or landing
Primary entry doors, required exit doors or secondary exterior doors with changes in height between the interior surface or floor level and the exterior surface or floor level shall comply...
-
Mockett DH3/BB Square Door Handle Installation Video
Hearty grip surface and solid, high density material and construction....
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work surface,...
-
DOE "Dear Colleague" Letter: Preventing Racial Discrimination in Special Education
I write to remind States, districts, and public schools, including charter schools, of their obligation under Title VI of the Civil Rights Act of 1964 (Title VI) not to discriminate on the...
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
BTX Intelligent Fashion Tumo Drapery System
For heavier or more custom applications, check out our Futura or Classic AC systems....
-
What other considerations are significant for persons with disabilities?
Thus, walks surfaced in these materials could not constitute an accessible route....
-
1133A.4.1 Repositionable countertops
Repositionable countertops shall comply with the following: Sinks and work surfaces required by Section 1133A.4 shall be designed to enable repositioning to a minimum height of 28...