Where openings are provided for transfer to amusement ride seats, the openings shall provide clearance for transfer from a wheelchair or mobility aid to the amusement ride seat....
Search Results "Latch Side Clearance"
Commonly Searched Documents
-
11B-1002.5.3 Transfer entry
-
39. Must an employer provide a reasonable accommodation that is needed because of the side effects of medication or treatment related to the disability, or because of symptoms or other medical conditions resulting from the underlying disability?
The side effects caused by the medication that an employee must take because of the disability are limitations resulting from the disability....
-
4.1 Introduction
counters, drinking fountains and other design features where knee and toe clearance is provided specifically to provide accessibility....
- Inclusion Solutions Poll Star Voting Booth
-
Unisex Toilet Rooms
Unisex toilet rooms must have a lavatory and privacy latch and cannot have more than two toileting fixtures (i.e., two water closets, or one water closet and one urinal)....
-
Car Controls [4.10.12]
Control panels must be located so that no floor button is higher than 54 inches for a side reach and 48 inches for a front approach....
-
RECOMMENDATIONS
Provide a minimum 24" clearance between any obstruction (e.g., sidewall) and the side of the toilet seat....
-
11B-902.2 Clear floor or ground space
Knee and toe clearance complying with Section 11B-306 shall be provided....
- Boost Your Business - Chapter 7 - Halls and Fountains
-
Location
As Gregory Scott, AIA, partner in RLPS, responded: "…the major challenge with the implementation of ADAAG, is not with excessive space requirements or even required clearances; but more...
- Landscape Forms Inc. Chase Park Trash Receptacle
-
11B-809.10.7.3 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Where water closets are not placed adjacent to a side wall capable of accommodating a grab bar, the bathroom shall...
-
Alternate Roll-In Type Shower Compartments: ADA Standard Section 608.5.3
Section 608.5.3 covers the current ADA Standards for controls in alternate roll-in type shower compartments.
-
11B-608.2.2 Standard roll-in type shower compartments
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
Dyson Airblade V Hand Dryer Side Elevation
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Bradley Towel Dispenser 250-15 Side Elevation
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Bradley MG Terreon Waste Receptacle Side Elevation
Requires the Premium User plan or above. (Login or upgrade your account!)
-
2004 ADA and ABA Accessibility Guidelines
criteria in the proposed standards are based on the 2004 ADA and ABA Accessibility Guidelines: • Height of transfer surfaces on diagnostic equipment used by patients in a supine, prone, or side-lying...
-
Attachment G: Modifications to Newly Constructed Facilities
Attachment G: Modifications to Newly Constructed Facilities
-
Additional Technical Criteria Considered for Handrails on Ramps
M303.3.3.5 would require handrails to be provided on each side of the ramp when the vertical rise of the ramp exceeds 6 inches....
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
Transit Shelters (R308.2) (Section-by-Section Analysis)
Some transit shelters are enclosed on three or four sides, with an opening for ingress and egress....
-
Transfer Space: ADA Standard Section 1008.3.1.3
The 48 inch (1220 mm) long minimum dimension of the transfer space shall be centered on and parallel to the 24 inch (610 mm) long minimum side of the transfer platform....