Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
Search Results "Latch Side Clearance"
-
404.2.8.1 Door Closers and Gate Closers
-
11B-604.8.2.3 Grab bars
A side-wall grab bar complying with Section 11B-604.5.1 shall be provided on both sides of the compartment....
-
11B-604.8.2.3 Grab bars
A side-wall grab bar complying with Section 11B-604.5.1 shall be provided on both sides of the compartment....
-
Cubicles and Counters: ADA Standard Section 232.5.1
Section 232.5.1 covers scoping requirements in the current ADA Standards for cubicles and counters.
-
Door Swing: ADA Standard Section 603.2.3
Section 603.2.3 covers the current ADA Standards for door swings at clear floor space and clearances at fixtures in toilet and bathing rooms.
-
11B-809.2.2 Turning space
It is generally acceptable to use required clearances to provide wheelchair turning space....
-
11B-809.2.2 Turning space
It is generally acceptable to use required clearances to provide wheelchair turning space....
-
NYC Board of Elections: Video 3 - Accessibility Clerk Responsibilities
-
Kitchen Appliances
In the addition, the Board has added exceptions for appliance doors and door latching devices in section 804.6.2. Comment....
-
Water Closet Location.
However, without research data upon which to determine how much space was adequate, side clearance varied, usually dependent on the amount of space available within the overall design of...
-
4.13.10* Door Closers
closer, then the sweep period of the closer shall be adjusted so that from an open position of 70 degrees, the door will take at least 3 seconds to move to a point 3 in (75 mm) from the latch...
-
4.13.10* DOOR CLOSERS
closer, then the sweep period of the closer shall be adjusted so that from an open position of 70 degrees, the door will take at least 3 seconds to move to a point 3 in (75 mm) from the latch...
-
11B-812.7.1 Location
Access aisles at vehicle spaces shall not overlap the vehicular way and may be placed on either side of the vehicle space they serve except for van accessible spaces which shall have access...
-
11B-812.7.1 Location
Access aisles at vehicle spaces shall not overlap the vehicular way and may be placed on either side of the vehicle space they serve except for van accessible spaces which shall have access...
-
Fur out the wall
The water closet shall be positioned with a wall or partition to the rear and to one side....
-
Figure 604.3.2 (Exception) Overlap of Water Closet Clearance in Residential Dwelling Units – Drawing from the U.S. Access Board
-
Bradley Towel Dispenser 252 Side Elevation
Requires the Premium User plan or above. (Login or upgrade your account!) -
11B-231.4.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....
-
11B-231.4.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....
-
11B-404.2.8.1 Door closers and gate closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
-
(1)(e)
Door latches and hardware should be operable with one hand and should not require tight grasping, pinching, or twisting of the wrist....
-
11B-232.5.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....
-
11B-232.5.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....
-
1015.2 Where required
Exception: Guards are not required for the following locations: On the loading side of loading docks or piers....
