(1) Except as provided in paragraph (b) of this section, this part does not prohibit discrimination against an individual based on that individual's current illegal use of drugs....
Search Results "Clearance in Base"
-
§ 35.131(a)(1)
-
4.2.6* SIDE REACH
If the side reach is over an obstruction, the reach and clearances shall be as shown in Fig. 6(c). Figure 6 Side Reach...
-
Clear Floor Space [§309.2]
Clear Floor Space Additional clearance is required if the space is obstructed on three sides for more than half the depth to allow easier maneuvering into the space....
-
704.5 TTY Shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (150 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
4.3.5.1 90-Degree Turn
4.3.5.1 90-Degree Turn This turning clearance is applicable for exterior and interior circulation, aisles in seating areas, ramps and other locations....
- Delta 1-1/2″ x 18″ ADA Grab Bar, Concealed Mounting 40118-PS
- Delta 1-1/2″ x 36″ ADA Grab Bar Concealed Mounting 40136-PS
- Delta 1-1/2″ x 42″ ADA Grab Bar Concealed Mounting 40142-SS
- Bobrick TrimLineSeries Countertop Mounted Paper Towel Dispenser B-526
- Boolee Voting Booth
-
M101.5 Dimensions (Section-by-Section Analysis)
The MDE NPRM proposed that the MDE Standards be based on adult dimensions and anthropometrics....
-
Technical Memorandum TM 2013-18 Sinks
804.4 Kitchens / Kitchenettes with Sinks If a sink is provided in a space that is subject to compliance with TAS 804 (Kitchen and Kitchenettes), the sink must comply with TAS 606 based...
-
§8.22(c)
percentage or number than that prescribed in paragraph (b) of this section for any area upon request therefor by any affected recipient or by any State or local government or agency thereof based...
-
Patient Toilet Rooms [6.4]
Patient Toilet Rooms [6.4] ADAAG specifications are based on the independent use of toilet and bathing facilities and do not address alternate designs for assisted use....
-
BACKGROUND
This matter is based upon a complaint filed with the United States Department of Justice, in which a Complainant alleged that Genesis discriminated against her on the basis of her disability...
-
Alterations: ADA Standard Section 223.1.1
Section 223.1.1 ADA Standards for alterations to medical care and long-term care facilities.
-
11B-411.2.1.2.3 Accessibility function button
Each dot shall have a base diameter of 0.059 inch (1.5 mm) minimum and 0.063 inch (1.6 mm) maximum and a height of 0.025 inch (0.6 mm) minimum and 0.037 inch (0.9 mm) maximum....
-
11B-411.2.1.2.3 Accessibility function button
Each dot shall have a base diameter of 0.059 inch (1.5 mm) minimum and 0.063 inch (1.6 mm) maximum and a height of 0.025 inch (0.6 mm) minimum and 0.037 inch (0.9 mm) maximum....
-
Actions
Etiquette considered appropriate when interacting with people with disabilities is based primarily on respect and courtesy....
-
Acknowledgements
Access Board or are based on illustrations produced by the U.S. Access Board and the U.S. Department of Justice....
-
§100.143(e)
(e) Determination of appropriate corrective action is fact-based. Not every corrective measure listed in paragraph (d) of this section need be taken for each likely violation....
-
Who is a person with a “record of” a disability under part 382?
Therefore, individuals who do not have an actual current impairment that substantially limits a major life activity would still be protected under part 382 based upon a past diagnosis (or...
-
11B-608.2.3 Alternate roll-in type shower compartments
FIGURE 11B-608.2.3 ALTERNATE ROLL-IN TYPE SHOWER COMPARTMENT SIZE AND CLEARANCE...