This modern L-shape Desk has no cross brace, allowing maximum knee space and complete freedom of movement. Push-button powered adjustment is smooth and practically silent....
Search Results "Cross Slope"
2010 ADA Definition
Cross Slope: The slope that is perpendicular to the direction of travel (see running slope).
-
Populas Vox Perfect Corner Workstation
-
Georgia-Pacific Cormatic® Automated Designer Series Towel Dispenser
Highly durable, long lasting dispenser Customized inserts available Reliable, hygienic touch free dispensing helps reduce risk of cross-contamination Operationally...
-
EZ-ACCESS Transitions® Angled Entry Mat
Beveled Edges The edges on the Transitions Angled Entry Mat have been beveled allowing cross-traffic access....
-
Pilot Rock AT Series Traditional A-Frame Picnic Table With Steel Braces - Using Lumber
Cross supports are formed using galvanized steel channel to build rigid end frames and a sturdy seat support. ...
-
E.
Cinemark's auditoria with 300 seats or less, persons who use wheelchairs cannot access the seating on risers as the wheelchair spaces available to them are located on the traditional, sloped-floor...
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
1009.5.2 Transfer Space
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
4.7.5 Sides of Curb Ramps
If a curb ramp is located where pedestrians must walk across the ramp, or where it is not protected by handrails or guardrails, it shall have flared sides; the maximum slope of the flare...
-
4.9.3 Nosings
Risers shall be sloped or the underside of the nosing shall have an angle not less than 60 degrees from the horizontal....
-
4.9.3 NOSINGS
Risers shall be sloped or the underside of the nosing shall have an angle not less than 60 degrees from the horizontal....
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
§ 38.159(c)(3) Ramp threshold
Changes in level between 1/4 inch (6.5 mm) and 1/2 inch (13 mm) shall be beveled with a slope no greater than 1:2....
-
§ 38.95(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
Maintenance
One site utilizing PIP as the primary access route and EWF as the secondary access route was assessed with less than 1 percent slope at the transition between the two surface materials. ...
-
1134A.6 Showers
Slope. The maximum slope of the shower floor shall be ½ inch (12.7 mm) per foot in any direction and shall slope to a drain....
-
Show us your #CrappyCurb
doesn't have a Curb Cut which is essentially a small ramp on or off the sidewalk, someone with a mobility disability who uses a cane, wheelchair, motorized scooter, or a walker can neither cross...
-
M303.3.2 Beveled (Section-by-Section Analysis)
proposed that for equipment with a change in level at the entry to the wheelchair space, level changes greater than ¼ inch but not greater than ½ inch would be required to be beveled with a slope...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
404.2.5 Thresholds
EXCEPTION: Existing or altered thresholds 3/4 inch (19 mm) high maximum that have a beveled edge on each side with a slope not steeper than 1:2 shall not be required to comply with 404.2.5...
-
E. Chapter 4: Boarding and Alighting
Responses to comments on the Board’s proposal in the 2010 NPRM to revise the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for...
-
Dispersion
Clustering wheelchair spaces is allowed only where sight line slopes exceed 5%, such as bleachers and balconies (or in alterations where dispersion is technically infeasible)....
-
Intent
Extensive use has been made by Evan Terry Associates (ETA) of "ETA Editor's Notes" for clarification, and of hyperlinks for internal cross-referencing and access to external materials and...
-
Intent
Extensive use has been made by Evan Terry Associates (ETA) of "ETA Editor's Notes" for clarification, and of hyperlinks for internal cross-referencing and access to external materials and...
