feet high single tier designer lockers 13-3/4" D for 15" deep designer lockers 16-3/4" D for 18" deep designer lockers 19-3/4" D for 21" deep designer lockers Options Sloping...
Search Results "Cross Slope"
2010 ADA Definition
Cross Slope: The slope that is perpendicular to the direction of travel (see running slope).
-
Salsbury Industries Designer Wood Locker Single Tier 1 Wide
-
A trailhead
For purposes of FSTAG, trailheads are not: Junctions between trails where there is no other access Intersections where a trail crosses a road or where users have developed...
-
11B-246.2 Camping facilities
at least two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope...
-
Ramps
For each elevated ramp run: 12-inch (305 mm) maximum rise 1:12 maximum slope 36-inch (915 mm) minimum clear width ...
-
4.1.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface slope, size, or location, the...
-
11B-246.2 Camping facilities
at least two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope...
-
11B-246.2 Camping facilities
at least two campsites and one additional campsite for each 100 campsites or fraction thereof, shall be accessed by and connected to sanitary facilities by travel routes with a maximum slope...
-
2.3
lines of sight comparable to those for members of the general public, (b) including wheelchair spaces as an integral part of the fixed seating plan, (c) providing the appropriate depth for cross...
-
Issue 6: Pre-timed signals (an APS is more than a pushbutton)
vibrotactile WALK; the tactile arrow for wayfinding; tactile mapping; if provided, and messages and actions available with an extended button push, such as audible beaconing or an extended crossing...
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
Bus boarding and alighting areas
be in compliance with the ADA-ABA Guidelines (Section 810.2), which address surfaces (sturdy), dimensions (96" long x 60" wide); connection to sidewalks, streets and pedestrian paths; slope...
-
Why is a top landing required at curb ramps if side flares are provided?
A landing at least 36” long at the top of curb ramps provides room to approach or exit ramps and turn without encountering compound slopes of flared sides....
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48. Figure 1009.2.2 Pool Lift Seat Location...
-
Accessible Miniature Golf Course Holes
least fifty percent (50%) of golf holes on miniature golf courses to be accessible, including providing a clear floor or ground space that is 48 inches minimum by 60 inches minimum with slopes...
-
1.15 Stadium-style seating, stadium section, or stadium seating
Each row of stadium seating is elevated above the row immediately ahead of it and is accessed by stepped, rather than sloped, aisles....
-
C. M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair
Board made four significant changes to this section: two significant changes to accommodate the unique challenges of mammography equipment; one significant change to the ramped running slope...
-
K. Eating Areas
Eating Areas An accessible route, at least 36 inches wide and without steps or steep slopes, must be provided to and throughout the food service and eating areas of the shelter....
-
7.4.9 Trail Facilities
When the surface of the required clear ground space for trail facilities is not paved or is not elevated above the natural ground, slopes not steeper than 1:20 (5 percent) shall be permitted...
-
4.2.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Where Ramps and Curb Ramps are Required [§303.4]
Portions of accessible routes with running slopes steeper than 5% also must be treated as ramps....
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
§ 38.83(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
-
§ 38.125(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....