For example, where there is not enough space to install a ramp with a slope that complies with the Standards, a business may install a ramp with a slightly steeper slope....
Search Results "Cross Slope"
Commonly Searched Documents
-
Readily Achievable Barrier Removal
-
1131B.2, Item 1
Vehicle standing spaces and access aisles shall be level with surface slopes not exceeding one unit vertical in 50 units horizontal (2-percent slope) in all directions....
-
8.2.1 Participants
Moderately-severe, gently sloping hearing loss: PTA is greater than 41 dB HL with threshold at 2000 Hz between 55 and 60 dB HL). 4....
-
1010.1.5 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
- AJW Architectural Products U136EA 54 oz. Automatic Liquid Soap Dispenser - Vanity Mounted
- Armor-Tile Tactile Systems Cast In Place Detectable Warning Surface System
- Mobility International USA (MIUSA)
-
Transfer Supports Location and Configuration M301.3 and M302.3
The shape (contours and curves along length for ergonomics, not cross sectional profile) was kept open to give manufacture flexibility in the design as the direction of positioning (i.e....
-
Additional Technical Criteria Considered for Handrails on Ramps
These technical criteria are available at http://www.access-board.gov/ada-aba/final.cfm#a505 and address continuity, height, clearance, gripping surface, cross section, surfaces, fittings...
-
Soiltac Powder Mix-In
Where there was water flow crossing the segment, the surface was soft under foot but returned to a natural surface state....
-
INTRODUCTION
Running, cross, and side slopes of curb ramps that are excessively steep; ii. Ramps that are too narrow to accommodate wheelchairs or scooters; iii....
-
Base Support [No specific provision—affects M303.2.4]
The subcommittee also discussed adding an allowance for a sloped region at the base of the gantry....
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 11B-303.3 Beveled....
- Diversified Woodcrafts Forward Vision ADA Workstation 2956KF-L-ADA
- ACO Premium Linear QuARTz Drain
- Salsbury Industries See Through Metal Locker Single Tier 3 Wide
- Salsbury Industries See Through Metal Locker Single Tier 1 Wide
- AJW Architectural Products U592 1.6 Gallon Sanitary Napkin Disposal w/ Keyed Access Panel & Mounted Shelf - Surface Mounted
- AJW Architectural Products U593 1.6 Gallon Sanitary Napkin Disposal w/ Mounted Shelf - Surface Mounted
-
Trash, Recycling, and Other Essential Containers
The slope of the clear space must not be steeper than 1:48 (2 percent) in any direction....
-
Re: American Specialties 9014 Surface Mounted Horizontal Baby Changing Station
The design of the hand hold is completely sloped at about 45 degrees. My fingers slipped off unless I applied tremendous pinching force to operate....
- Pilot Rock AT Series Traditional A-Frame Picnic Table With Steel Braces - Using Recycled Plastic
- Detectable Warning Systems, Inc. AlertTile® Detectable Warning
- Konica Minolta bizhub C224