Aisles with slopes no steeper than 1:12 are often feasible in small and medium size assembly areas and permit accessible routes that coincide with general routes....
Search Results "Cross Slope"
Commonly Searched Documents
-
Access to Performing Areas [4.33.5]
-
Landings [4.8.4]
Landings must be at least as wide as the ramp they serve and cannot slope more than 2% in any direction. Where ramps change direction, the landing must be at least 60 by 60 inches....
-
Vertical Clearance [§307.4]
Fixed barriers, such as guardrails, are required where the vertical clearance is less than 80” such as at open stairways and along sloped or curved walls....
-
Stairs
At the bottom, the handrail shall continue to slope for a distance of the width of one tread from the bottom riser; the remainder of the extension shall be horizontal (see Fig. 19(c) and...
-
11B-1003.2.2 Boarding piers at boat launch ramps
length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section 11B-405.2 _|Slope...
-
Entrances
Entrances Problem The entrance area must be level (no level change greater than ½ inch) and should not slope steeply in any one direction....
-
1132A.4 Level floor or landing
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
Road Roughness Analysis
(Loizos, 2008) PSD can also be evaluated in terms of roughness by plotting the PSD of elevation, PSD of slope, or vertical acceleration versus wavelength....
- Eastern Oregon Center for Independent Living (EOCIL) - Ontario, Pendleton, The Dalles, OR
- AJW Architectural Products U133 56 oz. One-Piece Liquid Soap Dispenser - Surface Mounted
- Spectrum Aquatics Gallatin Water Powered Assisted Access Lift
- Diversified Woodcrafts Forward Vision Workstation 2956K-L-ADA
- Salsbury Industries 61000 Series Single Tier Standard Metal Lockers
- Salsbury Industries 61000 Series Single Tier 3 Wide Standard Metal Lockers
-
Conditions for an Exception in FSTAG
Consider a trail intended to provide a rugged experience, such as a cross-country training trail with a steep grade or a fitness challenge course with abrupt and severe changes in elevation...
-
R205 Alternate Pedestrian Access Routes
Extra distance and additional pedestrian street crossings add complexity to a trip and increase exposure of risk to accidents....
-
221.2.3.2 Vertical Dispersion
Points of entry to bleacher seating may include, but are not limited to, cross aisles, concourses, vomitories, and entrance ramps and stairs....
-
Master Bedroom
Cross ventilation for fresh air while sleeping....
-
§ 38.159(b)(13) Handrails
The handrail shall have a cross-sectional diameter between 11/4 inches (32 mm) and 11/2 inches (38 mm) or shall provide an equivalent grasping surface, and have eased edges with corner radii...
-
§ 38.29(b)
Handrails shall have a cross-sectional diameter between 11/4 inches and 11/2 inches or shall provide an equivalent grasping surface, and have eased edges with corner radii of not less than...
-
Maneuvering Space
permits individuals with mobility devices to turn around A 60-inch (1525 mm) T-Shaped turn allows an individual to change directions by making a series of multi-point turns Slope...
-
R302.7.2 Vertical Surface Discontinuities
Vertical surface discontinuities between 6.4 mm (0.25 in) and 13 mm (0.5 in) shall be beveled with a slope not steeper than 50 percent....
-
Ramp
For example, some amusement park rides have sloped surfaces built into the structure of the ride vehicle to help individuals transfer into and out of the vehicle. ...