Cross braces are 1-5/16" OD steel pipe. FINISH: Standard finish: hot dip galvanized after fabrication. ...
Search Results "Cross Slope"
Commonly Searched Documents
- Pilot Rock SQT3-4 Series Square Portable Table - Using Lumber or Recycled Plastic
- 
    
  
  Section 1193.51 Compatibility [1193.41 in the NPRM] (Section-by-Section Analysis)
  It also required that all input to and control of a product shall allow for real time operation by electronic text input into a cross-industry standard external port and in cross-industry... 
- 
    
  
  Clear Floor or Ground Space
  ground space is also sometimes called "wheelchair parking space." 30-inch (760 mm) by 48-inch (1220 mm) minimum area May overlap accessible routes and maneuvering spaces Slope... 
- 
    
  
  505.6 Gripping Surface
  Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length... 
- 
    
  
  Parking
  Accessible parking spaces (including access aisles) must be level (maximum slope 1:48 in all directions) and each access aisle must adjoin an accessible route. Â ... 
- 
    
  
  Purpose of the project
  For instance, when this project began, tolerances for the measurement of the slope, flatness, and smoothness of exterior walking and rolling surfaces in concrete, asphalt, unit masonry,... 
- 
    
  
  11B-505.6 Gripping surface
  Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length... 
- 
    
  
  References
  Effects of cross slopes on the mobility of manual wheelchair users. International Seating Symposium; 2010; Vancouver, CA. 22.      LaPlante MP, Kaye HS.... 
- 
    
  
  Categorization of wheelchair versus other power-driven mobility devices. (Section-by-Section Analysis)
  facility by other recreational users, as well as their safety; on the administrative components of government agencies required to assess which devices are appropriate on narrow, steeply sloped... 
- 
    
  
  11B-809.8 Doors
  ., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25 mm), provided a ramp with a maximum slope of 1:8 is permanently installed as illustrated... 
- The Center for Independent Living Disability Resource Center (CIL - DRC) - Pensacola, FL
- National Organization on Disability (NOD)
- 
    
  
  A. ADA Basics for Emergency Management
  This requirement applies to programs, services, and activities provided directly by state and local governments as well as those provided through third parties, such as the American Red Cross... 
- 
    
  
  11B-221.2.3.2 Vertical dispersion
  Points of entry to bleacher seating may include, but are not limited to, cross aisles, concourses, vomitories, and entrance ramps and stairs.... 
- 
    
  
  R209 Accessible Pedestrian Signals and Pedestrian Pushbuttons (Section-by-Section Analysis)
  The pedestrian pushbutton has a locator tone for detecting the device and a tactile arrow to indicate which pedestrian street crossing is served by the device.... 
- 
    
  
  Study Limitations
  Three inline skaters traveling one after the other may require more time to cross an intersection than a single inline skater.... 
- 
    
  
  2004 ADA and ABA Accessibility Guidelines
  The Access Board is also considering additional technical criteria based on the 2004 ADA and ABA Accessibility Guidelines for cross section dimensions and clearances around gripping surfaces... 
- 
    
  
  11B-221.2.3.2 Vertical dispersion
  Points of entry to bleacher seating may include, but are not limited to, cross aisles, concourses, vomitories, and entrance ramps and stairs.... 
- 
    
  
  11B-221.2.3.2 Vertical dispersion
  Points of entry to bleacher seating may include, but are not limited to, cross aisles, concourses, vomitories, and entrance ramps and stairs.... 
- 
    
  
  Picnic Tables
  All new picnic table installations must comply with requirements for accessible seating spaces, table clearance, slope, and surface.... 
- 
    
  
  1118B.3
  Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B... 
- 
    
  
  T402 Ramps and Bridgeplates
  and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces, clear width, edge guards, running slope... 
- 
    
  
  Knee and Toe Clearance (M303.2.4)
  to reduce at rate of 1 inch in depth for every 6 inches in height 12 inches deep minimum at 28 inches above the floor Knee clearance is same depth throughout and not sloped... 
