12 [§ 4.7.9] When a curb ramp is located at a marked crossing, the area where the ramp run ends must be contained within the marked crossing....
Search Results "Vehicle Ramp"
-
12 [§ 4.7.9]
-
Sidewalks and Walkways
Some sidewalks do not include curb ramps or, if they do, the ramped section is too narrow or steep....
-
Q14: Application of Section 504 Safe Harbor to Curb Ramps Built in Compliance with 1991 ADAAG
Q14: Does the Section 504 safe harbor apply to curb ramps built in compliance with 1991 ADAAG during the time period when the requirement for detectable warnings was suspended and the roadway...
-
§ 38.93(d)(3) Exception
horizontal gap or vertical alignment specified in paragraph (d)(1) or (d)(2) of this section, car, platform or portable lifts complying with §38.95(b) of this part, or car or platform ramps...
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
1015.3 Height
On ramps and ramped aisles, from the ramp surface at the guard....
-
§ 38.95(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
- Guidance for Conducting Physical Functional Assessments for ADA Paratransit Eligibility
- CalCasp Training: 2016 California Building Code Chapter 11B
-
Problem Two (Accessible Route)
Problem Two: The accessible route crosses a curb and no curb ramp is provided. Solution: Install a portable ramp....
-
R207.1 General
A curb ramp, blended transition, or a combination of curb ramps and blended transitions complying with R304 shall connect the pedestrian access routes at each pedestrian street crossing....
-
T103 Definitions
transportation vehicles....
-
§ 38.125(c)(1) Design load
Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with...
-
3. Exception to Ramp Running Slope
A ramp in the built environment to which this exception applies may use a 1:2 grade slope on a short rise ramp....
-
1015.3 Height
On ramps and ramped aisles, from the ramp surface at the guard....
-
Governmental Units Affected (R208 Detectable Warning Surfaces) (Section-by-Section Analysis)
The Access Board seeks information on whether any state and local transportation departments currently use UFAS for curb ramps in the public right-of-way....
-
§ 38.57(b)
(b) Handrails, stanchions, and seats shall allow a route at least 32 inches wide so that at least two wheelchair or mobility aid users can enter the vehicle and position the wheelchairs...
-
8. Boarding Separately From Wheelchair
A wheelchair user's request to board a fixed route or paratransit vehicle separately from his or her device when the occupied weight of the device exceeds the design load of the vehicle...
- seca 664 Digital Wheelchair Scale with Wireless Transmission
-
Portable ramp - greater than six inch step
[See subsections ...]
-
R304.5.3 Cross Slope
The cross slope of curb ramps, blended transitions, and turning spaces shall be 2 percent maximum....
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
§ 38.125(c)(7) Stowage
A compartment, securement system, or other appropriate method shall be provided to ensure that stowed ramps or bridge plates, including portable ramps or bridge plates stowed in the passenger...
