CBC defines "path of travel" as: • "An identifiable accessible route within an existing site, building or facility by means of which a particular area may be approached, entered and exited...
Search Results "Horizontal Exit"
Commonly Searched Documents
- 
    
  
  "Path of travel"
  
 - 
    
  
  1132A.8 Hand-activated door hardware
  
Locked exit doors shall operate consistent with Section 1132A.6, in the direction of egress....
 - 
    
  
  1132A.8 Hand-activated door hardware
  
Locked exit doors shall operate consistent with Section 1132A.6, in the direction of egress....
 - 
    
  
  M305.2.2 Length (Section-by-Section Analysis)
  
The second commenter, a manufacturer, recommended revising the proposed provision from requiring the transfer support to extend horizontally the entire depth of the transfer surface, to...
 - 
    
  
  903 Benches
  
rule required back support to be provided that extends vertically from a point no more than 2 inches above the bench to a height of at least 18 inches above the bench and that extends horizontally...
 - 
    
  
  Trail Slopes
  
Slopes are often described as a ratio of vertical distance to horizontal distance, or rise to run (figure 130)....
 - HEWI Stationary Support Rail Mono WARM TOUCH
 - 
    
  
  Avoid the extremes of surface reflectivity and contrast (slides 11 and 13)
  
Does the white stringer help you identify where each of those steps is, having a contrast color for the vertical on the sides versus the horizontal of the tread?...
 - 
    
  
  405.9 Edge Protection
  
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (13 mm) maximum within 10 inches (255 mm) horizontally of the minimum landing area...
 - 
    
  
  405.9 Edge Protection
  
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (13 mm) maximum within 10 inches (255 mm) horizontally of the minimum landing area...
 - 
    
  
  Handrails
  
[ADA Stds. 4.9] Yes __ No __ N/A __ Comments: ___________________________________________ ...do the handrails extend horizontally at the top and bottom of each stair section to give...
 - 
    
  
  4.4.3 Backrest and Armrest
  
strength of backs, armrests, and mounting devices shall comply with section 903.6 of the ABAAS, which states: “Allowable stresses shall not be exceeded for materials used when a vertical or horizontal...
 - 
    
  
  Rotational Penetrometer
  
The test for stability requires the caster of the Rotational Penetrometer to be moved from side to side to determine the horizontal displacement of the surface material....
 - 
    
  
  405.9 Edge Protection
  
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of 1/2 inch (13 mm) maximum within 10 inches (255 mm) horizontally of the minimum landing area...
 - 
    
  
  11B-602.9 Pedestrian protection
  
When used, wing walls or barriers shall project horizontally at least as far as the drinking fountain and to within 6 inches (152 mm) vertically from the floor or ground surface....
 - 
    
  
  1010.1.5 Floor elevation
  
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
 - 
    
  
  1. Location
  
where people must walk to access bus stops and other public transportation stops, so, where necessary, curb ramps must also be provided to enable people with disabilities to board and exit...
 - 
    
  
  Vertical Clearance [4.6.5]
  
In garages, at least one vehicular route connecting van spaces to entrances and exits must provide this clearance; van spaces can be clustered on one level....
 - 
    
  
  2. a. iv. Path-of-Travel (wheelchair) space allowances
  
If a 180° turn is needed to exit an area, then a 60” diameter turning space or a 36” wide "T" is needed (see Figure 11)....
 - 
    
  
  General [5.1]/ Access Aisles [5.3]
  
Space should also be available so that people using wheelchairs do not obstruct required exit and circulation routes....
 - Seton Custom SetonGlo™ Floor & Stair Identification Signs AV0154
 - Norton Surface Mounted Series 5600 Hands-Free Door Operation Kits
 - 
    
  
  Sloped Surfaces
  
The amount of slope or grade is described as the proportion of a vertical rise to a horizontal length....
 - 
    
  
  Running Slope [1017.7.1]
  
Running slope is often described as a ratio of vertical distance to horizontal distance, or rise to run (figure 9)....