The minimum acceptable time from notification that a car is answering a call until the doors of that car start to close shall be calculated from the following equation: T = D/(1.5 ft/...
Search Results "Assurances from Contractors"
-
11B-407.3.4 Door and signal timing
-
11B-407.3.4 Door and signal timing
The minimum acceptable time from notification that a car is answering a call until the doors of that car start to close shall be calculated from the following equation: T = D/(1.5 ft/...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
Side Wall: ADA Standard Section 604.5.1
Section 604.5.1 covers the current ADA Standards for side wall grab bars that are used for water closets.
-
Vertical Clearance: ADA Standard Section 503.5
Section 503.5 covers the current ADA Standards for the vertical clearance at passenger loading zones.
-
11B-404.2.4.1 Swinging doors and gates
Approach direction Door or gate side Perpendicular to doorway Parallel to doorway (beyond latch side unless noted) From...
-
11B-404.2.4.1 Swinging doors and gates
Approach direction Door or gate side Perpendicular to doorway Parallel to doorway (beyond latch side unless noted) From...
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
D. Technical standards for construct validity studies
Users choosing to justify use of a selection procedure by this strategy should therefore take particular care to assure that the validity study meets the standards set forth below....
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
-
11B-404.2.4.2 Doorways without doors or gates, sliding doors, and folding doors
MANEUVERING CLEARANCE Approach direction Perpendicular to doorway Parallel to doorway (beyond stop/latch side unless noted) From...
-
11B-404.2.4.2 Doorways without doors or gates, sliding doors, and folding doors
MANEUVERING CLEARANCE Approach direction Perpendicular to doorway Parallel to doorway (beyond stop/latch side unless noted) From...
-
Doorways without Doors or Gates, Sliding Doors, and Folding Doors: ADA Standard Section 404.2.4.2
Section 404.2.4.2 covers the current ADA Standards for maneuvering clearances at doorways without doors or gates, sliding doors, and folding doors.
-
Introduction
impairments, but also members of the park’s exhibit planning, cultural resources compliance staff, interpretive staff and Diversity Committee staff, representatives of the wayside design contractor...
-
11B.707.7.1.3 Horizontally mounted display screen
Where display screens are mounted tipped away from the viewer 60 degrees to 90 degrees (horizontal) from vertical, the center line of the display screen and other display devices shall be...
-
11B.707.7.1.3 Horizontally mounted display screen
Where display screens are mounted tipped away from the viewer 60 degrees to 90 degrees (horizontal) from vertical, the center line of the display screen and other display devices shall be...
-
Maintenance
The playground crews ranged in number from 1‒3 staff, usually with one full-time employee and 2‒3 seasonal staff during the summer months. At least 30 minutes was spent on site. ...
-
Accessibility - Flatness and Lippage
For any application, a tiled floor should comply with the flatness requirements in ANSI A108.02: "no variations exceeding 1/4" in 10 feet from the required plane."...
-
11B.707.7.1.2 Angle-mounted display screen
Where display screens are mounted tipped away from the viewer 30 degrees to less than 60 degrees from vertical, the center line of the display screen and other display devices shall be no...
-
Depth: ADA Standard Section 802.1.3
Where a wheelchair space can be entered from the front or rear, the wheelchair space shall be 48 inches (1220 mm) deep minimum....
-
11B.707.7.1.2 Angle-mounted display screen
Where display screens are mounted tipped away from the viewer 30 degrees to less than 60 degrees from vertical, the center line of the display screen and other display devices shall be no...
-
11B-610.3 Shower compartment seats
In transfer-type showers, the seat shall extend from the back wall to a point within 3 inches (76 mm) of the compartment entry....