QuikTrip will ensure that persons with disabilities have an equal opportunity to benefit from the goods, services, privileges, advantages, and accommodations offered by QuikTrip through...
Search Results "Assurances from Contractors"
-
EXHIBIT H POLICY OF NONDISCRIMINATION ON THE BASIS OF DISABILITY IN EFFECTIVE WEBSITE COMMUNICATIONS
-
11B-104.1.1 Construction and manufacturing tolerances
Information on specific tolerances may be available from industry or trade organizations, code groups and building officials, and published references....
-
11B-104.1.1 Construction and manufacturing tolerances
Information on specific tolerances may be available from industry or trade organizations, code groups and building officials, and published references. ...
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
-
1015.3 Height
Required guards shall not be less than 42 inches (1067 mm) high, measured vertically as follows: From the adjacent walking surfaces....
-
II. COMPLIANCE WITH TITLE III OF THE ADA
provide a copy of the policy to each new Web Content Personnel, contractor responsible for web content, and CSO Personnel for www.hrblock.com; c. ...
-
Spout Location: ADA Standard Section 602.5
Section 602.5 covers the current ADA Standards for the spout location of drinking fountains.
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers....
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers....
-
Figure 404.2.4.1(k) Maneuvering Clearances at Manual Swinging Doors and Gates: Latch Approach, Push Side with Closer – Drawing from the U.S. Access Board
-
Figure 404.2.4.1(i) Maneuvering Clearances at Manual Swinging Doors and Gates: Latch Approach, Pull Side with Closer – Drawing from the U.S. Access Board
-
Door Closers and Gate Closers: ADA Standard Section 404.2.8.1
Section 404.2.8.1 covers the current ADA Standards for the closing speed of door closers and gate closers.
-
11B-404.2.8.1 Door closers and gate closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
-
11B-404.2.8.1 Door closers and gate closers
Door closers and gate closers shall be adjusted so that from an open position of 90 degrees, the time required to move the door to a position of 12 degrees from the latch is 5 seconds minimum...
-
D. Technical standards for construct validity studies
Users choosing to justify use of a selection procedure by this strategy should therefore take particular care to assure that the validity study meets the standards set forth below....
-
Rebuilding Together East Bay-North - Berkeley, CA
We can only do this with the support of roughly 1,000 volunteers and donations from individuals, corporations, private foundations, and small business owners....
-
Size: ADA Standard Section 604.3.1
Section 604.3.1 covers the current ADA Standards for the size of the water closet clearance.
-
B.2.ii. - How should an agency proceed in identifying "applicable" technical provisions in Subparts B, C, and D of the Access Board’s standards to ensure acquired products provide comparable access?
For example, if an agency were to enter into a seat management contract for desktop computing resources, the hardware and software to be provided by the contractor would be required to meet...
-
Maintenance
The playground crews ranged in number from 1‒3 staff, usually with one full-time employee and 2‒3 seasonal staff during the summer months. At least 30 minutes was spent on site. ...
-
Accessibility - Flatness and Lippage
For any application, a tiled floor should comply with the flatness requirements in ANSI A108.02: "no variations exceeding 1/4" in 10 feet from the required plane."...
-
Introduction
impairments, but also members of the park’s exhibit planning, cultural resources compliance staff, interpretive staff and Diversity Committee staff, representatives of the wayside design contractor...
-
Conventions Used In This Guide
Font Convention Meaning Black Text Used for text taken from CBC Black Text, Italicized...
-
Conventions Used In This Guide
Font Convention Meaning Black Text Used for text taken from CBC Black Text, Italicized...
-
Doors: ADA Standard Section 604.8.1.2
Section 604.8.1.2 covers the current ADA Standards for wheelchair accessible compartment doors.
