In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
Search Results "Residential Structure"
Filters
Commonly Searched Documents
-
11B-804.3 Kitchen work surface
-
11B-607.4 Grab bars
In residential dwelling units, grab bars shall not be required to be installed in bathtubs located in bathing facilities provided that reinforcement has been installed in walls and located...
-
11B-604.5 Grab bars
In residential dwelling units, grab bars shall not be required to be installed in toilet or bathrooms provided that reinforcement has been installed in walls and located so as to permit...
-
11B-233.3.1.2.6.4 Test number three, unusual characteristics test
located in a state or federally designated floodplain or coastal high-hazard areas and sites subject to other similar requirements of law or code that require the lowest floor or the lowest structural...
-
F233.2 Residential Dwelling Units Provided by HUD or Through Grant or Loan Programs Administered by HUD
Where facilities with residential dwelling units are provided by the Department of Housing and Urban Development (HUD), or through a grant or loan program administered by HUD, residential...
-
Section 36.401 New Construction (Preamble, Section-by-Section Analysis)
Section 36.401 New Construction General Section 36.401 implements the new construction requirements of the ADA. Section 303 (a)(1) of the Act provides that discrimination for...
-
[ADA Title III] Maximum Extent Feasible
[ADA Title III] Maximum Extent Feasible. [§36.402(c)] The phrase "to the maximum extent feasible," as used in this section, applies to the occasional case where the nature of an...
-
§ 36.401 New construction.
[See subsections ...]
-
Sec.36.401 New construction
Sec.36.401 New construction.
-
Additions [4.1.5]
Each addition to an existing building is regarded as an alteration subject to ADAAG alterations requirements (including triggering of path of travel obligations, if applicable). To...
-
4.1.6(3)(c)(ii)
(ii) Where existing shaft configuration or technical infeasibility prohibits strict compliance with 4.10.9, the minimum car plan dimensions may be reduced by the minimum amount...
-
Alterations: Alternate Stalls
Alterations: Alternate Stalls An alternate stall may be substituted for the standard stall only in alterations where full compliance with requirements for a wheelchair accessible...
-
4.1.6(3)(c)
(c) The following toilet facilities, whichever is greater: (i) At least one toilet facility for each sex in the altered building complying with 4.22, Toilet Rooms, and 4.23,...
-
III-5.0000 NEW CONSTRUCTION
[See subsections ...]
-
Section 36.401 New Construction (Section-By-Section Analysis and Response to Comments)
Section 36.401 New Construction (Section-By-Section Analysis and Response to Comments) General Section 36.401 implements the new construction requirements of the ADA. Section...
-
608.3 Grab Bars (Exception 2)
608.3 Grab Bars (Exception 2) Exception 2 to this section permits grab bars to not be installed in shower compartments in residential dwelling units required to provide mobility features...
-
607.4 Grab Bars (Exception 2)
607.4 Grab Bars (Exception 2) Exception 2 to this section permits grab bars to not be installed at bathtubs in residential dwelling units required to provide mobility features provided...
-
1.9.1 Division of the State Architect - Access Compliance.
Additions, alterations and structural repairs in all buildings and facilities shall comply with these provisions for new buildings, except as otherwise provided and specified herein....
-
1.9.1 Division of the State Architect - Access Compliance.
Additions, alterations and structural repairs in all buildings and facilities shall comply with these provisions for new buildings, except as otherwise provided and specified herein....
-
11B-608.3 Grab bars
In residential dwelling units, grab bars shall not be required to be installed in showers located in bathing facilities provided that reinforcement has been installed in walls and located...
-
1.9.1 Division of the State Architect ─ Access Compliance
Additions, alterations and structural repairs in all buildings and facilities shall comply with these provisions for new buildings, except as otherwise provided and specified herein....
-
11B-804.3 Kitchen work surface
In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
-
1133A.2.1 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, countertop or the face of any appliance (excluding handles and controls) that projects into the kitchen and...
-
Accessible Routes in Dwelling Units with Mobility Features
Accessible Routes in Dwelling Units with Mobility Features. Sections 4.34.1 and 4.34.2 of the UFAS require the living area, kitchen and dining area, bedroom, bathroom, and laundry...