The guidelines require handrails to be continuous within the full length of stair flights and ramp runs (505.3)....
Search Results "Full Length Mirror"
-
Handrails
-
222.1 General
For example, in a physician's office, if people without disabilities must traverse the full length of the office suite in clothing other than their street clothes, it is acceptable for people...
-
AJW Architectural Products U6184 Unidoor C-fold/Multifold Towel Dispenser & Waste Receptacle Combination - Recessed
Uni-Door: Fabricated of #18 ga stainless steel with #4 satin finish with full length door stop to prevent vandalism Towel Dispenser: Dispensing area has hemmed edges to prevent injury...
-
AJW Architectural Products U640 Series C-fold/Multifold Towel Dispenser & Waste Receptacle Combination - Recessed
Cabinet Door: Fabricated of #22 ga stainless steel with #4 satin finish with full length door stop to prevent vandalism Towel Dispenser: Dispensing area has hemmed edges to prevent injury...
-
AJW Architectural Products U230 Series C-fold/Multifold Towel Dispenser - Recessed
Full length door stops protect door from vandalism....
-
Sec.36.401(c)(1)
(1) Full compliance with the requirements of this section is not required where an entity can demonstrate that it is structurally impracticable to meet the requirements....
-
§ 37.41(b)(1)
(1) Full compliance with the requirements of this section is not required where an entity can demonstrate that it is structurally impracticable to meet the requirements....
-
203.15.1
203.15.1 Full compliance with the requirements of this section is not required where an entity can demonstrate that it is structurally impracticable to meet the requirements....
-
Running Slope [1017.7.1]
Trails or trail segments of any length may be constructed with running slopes up to 1:20 (5 percent)....
-
§ 35.151(a)(2)(i)
(i) Full compliance with the requirements of this section is not required where a public entity can demonstrate that it is structurally impracticable to meet the requirements....
-
§ 36.401(c)(1)
(1) Full compliance with the requirements of this section is not required where a public entity can demonstrate that it is structurally impracticable to meet the requirements....
-
§ 35.151(a)(2)(i)
(i) Full compliance with the requirements of this section is not required where a public entity can demonstrate that it is structurally impracticable to meet the requirements....
-
Running Slope [1018.7.1]
When the running slope of a segment of beach access route is steeper than 1:20 (5 percent), the maximum length of the segment is specified in table 6, and a resting interval must be provided...
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
11B-809.8.3 Door maneuvering clearance.
At the dwelling unit side of the primary entry doors, secondary exterior doors, and required exit doors maneuvering clearances shall be 44 inches (1118 mm) minimum in length measured...
-
221.2.3.1 Horizontal Dispersion
shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile of the total row length...
-
221.2.3.1 Horizontal Dispersion
shall not be required in assembly areas with 300 or fewer seats if the companion seats required by 221.3 and wheelchair spaces are located within the 2nd or 3rd quartile of the total row length...
-
Landings: ADA Standard Section 406.4
Section 406.4 covers the current ADA Standards for curb ramp landings.
-
Sales and Service Counters: ADA Standard Section 904.4
shall be permitted to have a portion which is 24 inches (610 mm) long minimum complying with 904.4.1 provided that the required clear floor or ground space is centered on the accessible length...
-
§ 37.131(f)(3)(i)(C)
(C) Substantial numbers of trips with excessive trip lengths....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
-
11B-812.1 General
Exception: Where vehicle spaces or access aisles are not adjacent to another vehicle space, access aisle, or parking space, measurements shall be permitted to include the full width of the...
