Satin finish Stainless Steel Towel dispenser For Installation Behind Wall or Mirror For 1/2" Thick Drywall Installation For 5/8" Thick Drywall, use...
Search Results "Full Length Mirror"
Commonly Searched Documents
- Bradley In-Wall Towel Dispenser 198
-
1133A.4, Item 2
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
-
1133A.4, Item 2
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for a work surface....
-
Handrail Extensions: ADA Standard Section 505.10
Section 505.10 covers the current ADA Standards for handrail extensions.
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-404.2.4 Maneuvering clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance. Exception: Reserved....
-
B. The 2010 Standards Regarding Public Entrances Are Intended To Achieve the Same Result As the 1991 Standards Regarding Public Entrances
of any place of public accommodation.” 42 U.S.C. § 12182(a); see also 28 C.F.R. § 36.201 (regulatory language mirroring the statutory prohibition against discrimination on the basis of...
- Gamco Horizontal Wall-Mounted Baby Changing Station Cream - BCS-1
- Gamco Horizontal Wall-Mounted Baby Changing Station Grey - BCS-2
-
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
11B-505.6 Gripping surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
-
1017.7 Slopes
This section contains technical requirements for the maximum running slope and segment length (1017.7.1) and cross slope (1017.7.2) of trails....
-
1133A.4, Item 1
A minimum linear length of 30 inches (762 mm) of countertop shall be provided for the kitchen sink installation....
- Just Manufacturing Classroom Deck Mount Lever Handle Faucet
- Pilot Rock WPTS Square Frame Table Using Recycled Plastic
- Pilot Rock WPTS Square Frame Table Using Lumber
-
Section 37.139 Plan Contents
There is no document length requirement, however. Each entity (or group plan) is unique and we expect the plans to reflect this....
-
11B-812.7.2 Marking
Access aisle markings may extend beyond the minimum required length....
-
Selection of Variables
Selection of Variables Our own review of the ADAAG requirements, plus that of our subcontractor KRW, reveals that the single most needed anthropometric datum, by far, is arm length....
-
Side Transfer Surface
A transfer surface located within the length of the examination surface that allows patient transfer on two opposing sides of the examination surface....
-
M305.2.1.1 End Transfer Supports
Transfer supports for transfer surfaces complying with M301.2.3.1 and M302.2 shall be located on the short side (length) opposite the transfer side....
-
6.8.1 Size
The resting interval length shall be a minimum of 60 inches (1525 mm) long by 60 inches (1525 mm) wide....
-
5.8.1.1 Clear Platform Size
The platform should be a minimum clear width of 32-inches and a minimum clear length of 40-inches....