In new construction, full compliance with the requirements of these standards is not required where an entity can demonstrate that it is structurally impracticable to meet the requirements...
Search Results "Full Length Mirror"
Filters
Commonly Searched Documents
-
106.5.66 Structural Impracticability
-
III-4.4300 Standards to apply
Deviations from ADAAG are acceptable only when full compliance with those requirements is not readily achievable....
-
Pilot Rock WXT and WXTH Picnic Table Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables. ...
-
Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables. ...
-
Bobrick Recessed Paper Towel Dispenser B-318
Towels load into bottom of cabinet concealed behind wall or mirror; only the towel tray is visible....
-
Conclusions
A depth of 15in. for a seating surface was found to be suitable based on median values of buttock-popliteal length and wheelchair seat depths....
-
1017.4 Passing Spaces
Where the full length of a trail does not fully comply with the technical requirements in 1017, a passing space is required to be located at the end of the trail segment that fully complies...
-
Using the Tape Measure
A tape measure is used to measure the length, width, height, and depth of various elements including parking spaces and access aisles, routes, thresholds, doorways, and protruding objects...
-
§382.133(f)(3)
(3) The maximum weight and dimensions (length, width, height) of the device to be used by an individual that can be accommodated in the aircraft cabin consistent with the safety regulations...
-
C1-3. Accessible Route Width
If No, the accessible route may narrow to 32 inches wide for up to 2 feet in length. Yes _____ No _____...
-
11B-1003.2.2 Boarding piers at boat launch ramps
Where the total length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section...
-
Bobrick ClassicSeries Surface-Mounted Soap Dispenser B-42
Concealed wall/mirror mounting, removable for cleaning. Unit 5 13⁄16" W, 6 7⁄8" H (150 x 175mm); wall to push-button, 3 3⁄16" (80mm)....
-
1017.8 Resting Intervals
This section contains the technical requirements for the length (1017.8.1), width (1017.8.2), and slope (1017.8.3) of resting intervals; and for a turning space (1017.8.4) where resting...
-
Pilot Rock WPTS Square Frame Picnic Table Using Formed Steel Channel
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
Pilot Rock WPTS Square Frame Table Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
406.8 Detectable Warnings
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum...
-
4.1.1(5)(a)
Full compliance will be considered structurally impracticable only in those rare circumstances when the unique characteristics of terrain prevent the incorporation of accessibility features...
-
Attachment B – Code References
rehabilitation, reconstruction, historic restoration, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
-
Cavity Sliders USA Inc. FH Ceiling Mount Track
CS FH-Ceiling Mount Track is supplied with full-length fins or packers that enable the ceiling lining to be fixed flush with the underside of the track....
-
M305.3.1.1 Horizontal Position
The length of gripping surfaces on horizontal standing supports shall be 4 inches (100 mm) minimum except for diagnostic equipment containing a wheelchair space which shall comply with M305.3.1.2...
-
Sec.36.309(c)(2)
(2) Required modifications may include changes in the length of time permitted for the completion of the course, substitution of specific requirements, or adaptation of the manner in which...
-
§ 36.309(c)(2)
(2) Required modifications may include changes in the length of time permitted for the completion of the course, substitution of specific requirements, or adaptation of the manner in which...
-
Bobrick ClassicSeries Surface-Mounted Soap Dispenser B-40
Concealed wall/mirror mounting, removable for cleaning. Unit 5 13⁄16" W, 6 7⁄8" H (150 x 175mm); wall to push-button, 3 3⁄16" (80mm)....
-
Handrail Extensions [§505.10]
The length is measured to the start of the return radius....
