Figure 4.3.3(a) illustrates the terminology and the location on a mammography device that the Committee used to describe mammography components....
Search Results "Parking Location"
Filters
Commonly Searched Documents
-
4.4.3 Implications of Mammography Equipment Components
-
QUESTION: HOW IS IT DETERMINED WHAT KIND OF AUXILIARY AID OR SERVICE A PVO WILL PROVIDE TO A PASSENGER WITH A DISABILITY?
*Because locating a sign language interpreter to provide services to a passenger on some types of voyages can be time-consuming and difficult for PVOs, it is particularly important for passengers...
-
F244.2 Camping Units with Mobility Features
Entities should provide information on the location of camping units with mobility features on websites, in brochures, and at bulletin boards or information kiosks at the camping facility...
-
Accessible Routes on the Playing Surface
Designers should consider locating this opening in an area where the ball is not likely to roll....
-
Alternative Golf Car Passage
The golf car passage could be located on areas such as fairways, greens, and teeing surfaces....
-
Technical Memorandum TM 2013-14 Dining Surfaces
Therefore, accessible dining surfaces shall be 30” minimum in length based on 305.5 or 36” minimum if the clear floor space is located in an alcove based on TAS 305.7.1. ...
-
Technical Memorandum TM 2013-23 Storage (Not in Kitchens or Kitchenettes)
compliance with TAS 225.2, the Department shall consider base and wall cabinets to be the same type of storage if designed the same (i.e. both have doors), used for the same purpose, and located...
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations The Committee recommends standing supports located on both sides of platforms,...
-
1002.6 Transfer Devices for Use with Amusement Rides
Where possible, designers are encouraged to locate the transfer device seat no higher than 17 to 19 inches (430 to 485 mm) above the load and unload surface....
-
5.3.2.2 Transfer Sides Recommendation for Imaging Equipment
Imaging manufacturers noted that many X-ray system tables and all DXA tables with today’s technology have part of the imaging equipment support located on one of the long sides and all patient...
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
The mechanical system necessary to raise the table are located in the base of the table, beneath the seating surface....
-
Water Hydrants and Water Spouts [1011.2, 1011.3, and 1011.6]
The clear ground space must be located so that the water spout is between 11 and 12 inches from the rear center of the long side of the space....
-
M301.2.3 Transfer Surface Transfer Sides
However, many X-Ray system tables and all DXA tables will have part of the imaging equipment support located on one of the long sides and only all transfers are made from the other....
-
Continuous Width (R302.3) (Section-by-Section Analysis)
The proposed guidelines specify a minimum width of 1.2 meters (4 feet) in order to allow for street furniture and other objects that may be located on sidewalks....
-
Scenario 8 – Accessibility
School districts are required to have procedures in place to ensure that parents, students, and other interested persons can obtain information about the location of services, activities...
-
Initial Measures and Transfer Setup
This location was chosen to account for any hammocking, wear or compression of the seat upholstery and/or cushion. ...
-
OTHER SPECIFIC BARRIERS
Exhibit A to this Complaint identifies missing and Inaccessible curb ramps at various locations within the City's pedestrian right of way....
-
C.2. - If EIT is acquired through another agency’s contract, which agency is responsible for Section 508 compliance?
., the vendor’s or other exact web site location). See FAR 39.203(b)(2) (which imposes this requirement on all contracting offices that award IDIQ contracts)....
-
Introduction of new § 35.152 for detention and correctional facilities. (Section-by-Section Analysis)
requirements to ensure accessibility when a correctional or detention facility alters cells; 2) specifying that public entities shall not place inmates or detainees with disabilities in locations...
-
Example: Town Library is a Historic Property
Library staff may also meet with an individual in another accessible location when the telephone service is not effective....
-
What is an Accessible Seat and Who Can Use One?
Accessible seats are spaces specifically designed for wheelchairs and include features such as an accessible approach, location at grade, clear floor space, and larger dimensions....
-
Questions Posed in the NPRM Regarding Costs and Benefits of Complying With the 2010 Standards (Section-by-Section Analysis)
., side reach, water closet clearances in single-user toilet rooms with in-swinging doors, stairs, elevators, location of accessible routes to stages, accessible attorney areas and witness...
-
223.1 General
Locate accessible rooms near core areas that are less likely to change over time....
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
These two exceptions allow ICT to provide space beneath operable controls for ICT for knees and toes, or a portion of knees and toes, depending on the location of the controls....