Baseboard electrical outlets used in relocatable partitions, window walls or other electrical convenience floor outlets are not subject to the minimum height requirements. 4....
Search Results "Minimum Dimension"
-
1136A.1 Receptacle heights
-
404.2.4.1 Swinging Doors and Gates
Table 404.2.4.1 Maneuvering Clearances at Manual Swinging Doors and Gates Type of Use Minimum Maneuvering Clearance Approach Direction...
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
Sites where either Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, a minimum of 20 percent of the ground floor...
-
11B-809.12 Electrical receptacles, controls and switches
controls and switches shall be located as follows: Where there is no obstruction, 48 inches (1219 mm) maximum measured from the top of the receptacle box and 15 inches (381 mm) minimum...
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
1011.2.1 Size and Location
Outdoor Constructed Feature Minimum Size and Location Picnic tables 36 inches (915 mm) on all usable sides of the table measured from...
-
Volume Control
Some commenters specifically recommended a minimum 25 decibels or greater....
-
1011.2.1 Size and Location
Table 1011.2.1 Clear Ground Space Outdoor Constructed Feature Minimum Size and Location Picnic tables 36 inches (915 mm) on all usable sides of...
-
III 3.11000 Insurance
ILLUSTRATION: An amusement park requires individuals to meet a minimum height requirement that excludes some individuals with disabilities for certain rides because of a limitation in its...
-
Accessible Entrance
Landing extends 18" minimum beyond the edge of door and 60" minimum out from door. New landing and ramp eliminates step at entrance....
-
Fire Rings, Grills, Fireplaces, and Wood Stoves
This space may be reduced to 36 inches (915 millimeters) minimum where a condition for exception exists....
-
3. Statutory and Regulatory Background
We are required by section 502 of the Rehabilitation Act to establish and maintain minimum guidelines and requirements for the accessibility standards adopted the federal agencies....
-
General Comments (Preamble, Section-by-Section Analysis)
Many of these objections have been lodged on the basis that ADAAG exceeds the statutory mandate to establish ‘‘minimum’’ guidelines....
-
M301.2.1 Transfer Surface Height
Rationale: For many types of imaging equipment it will not be feasible to provide a transfer surface meeting the considered minimum height whether it is 17, 18, or 19 inches....
-
General Comments (Section-By-Section Analysis and Response to Comments)
Many of these objections have been lodged on the basis that ADAAG exceeds the statutory mandate to establish "minimum'' guidelines....
-
11B-250.1 General
Physical separation shall be provided with circulation paths raised 4 inches (102 mm) minimum above the area where vehicular traffic occurs....
-
11B-250.1 General
Physical separation shall be provided with circulation paths raised 4 inches (102 mm) minimum above the area where vehicular traffic occurs....
-
Fulton County - Diversity and Civil Rights Compliance Officer II
Minimum Qualifications: Bachelor's Degree in Public Administration, Business Administration, Human Resources, Construction Management/Architecture or a related field required; five years...
-
"Wheelchair" (Section-by-Section Analysis)
The Department does not propose to define specific dimensions that qualify a device as a wheelchair. ...
-
"Wheelchair" (Section-by-Section Analysis)
The Department does not propose to define specific dimensions that qualify a device as a wheelchair. ...
-
TABLE OF CONTENTS
TABLE OF CONTENTS CHAPTER 1: APPLICATION AND ADMINISTRATION 101 Purpose 102 Dimensions for Adults and Children 103 Equivalent Facilitation 104 Conventions...
-
Wheelchairs and Other Power-Driven Mobility Devices
Public entities must consider these factors in determining whether to permit other power-driven mobility devices on their premises: the type, size, weight, dimensions, and speed of...
-
Two-tiered definitional approach. (Section-by-Section Analysis)
In making such a determination, a public accommodation must consider the device's type, size, weight dimensions, and speed; the facility's volume of pedestrian traffic; the facility's design...
-
Categorization of wheelchair versus other power-driven mobility devices. (Section-by-Section Analysis)
The Department will not foreclose any future technological developments by identifying or banning specific devices or setting restrictions on size, weight, or dimensions....