At minimum, those policies will provide that the City: will not discriminate on the basis of disability in its hiring or employment practices....
Search Results "Minimum Dimension"
-
EMPLOYMENT
-
III. Results of the Study
Data collection concluded in September 2012 so that all playground sites in the study would have a minimum of two years data. ...
-
Reporting
The Report shall include, at a minimum, a description of the nature of the allegation, the name and contact information of the individual bringing the allegation, and documents in the City...
-
RECOMMENDATIONS
Provide a minimum 24" clearance between any obstruction (e.g., sidewall) and the side of the toilet seat....
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
F244.2 Camping Units with Mobility Features
Table F244.2 Camping Units with Mobility Features Total Number of Camping Units Provided in Camping Facility Minimum Number of Camping Units with Mobility Features Required...
-
Identification [§216.5, §502.6]
Signs can be on posts, or where feasible, on walls or suspended from ceilings (an 80” minimum headroom clearance is required at signs suspended above circulation paths (§307.4))....
-
2. What is the most integrated setting under the ADA and Olmstead in the context of a state and local government’s employment service system?
Such settings are commonly referred to as competitive integrated employment settings.17 An example of a competitive integrated employment setting is work on a full- or part-time basis, at minimum...
-
§ 38.83(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches high....
-
§ 38.125(b)(5) Platform barriers
Each side of the lift platform which, in its raised position, extends beyond the car shall have a barrier a minimum 11/2 inches high....
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
§ 38.23(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches high....
-
11B-220.2 Point-of-sale devices
Where more than one point-of-sale device is installed for use with a specific type of motor fuel, a minimum of two for that type shall comply with Sections 11B-707.2, 11B-707.3, 11B-707.7.2...
-
§ 38.159(b)(5) Platform barriers
Each side of the lift platform which extends beyond the vehicle in its raised position shall have a barrier a minimum 11/2 inches (13 mm) high....
-
Section 37.153 FTA Waiver Determination
This requirement stems from the statutory provision that the Administrator can require the entity to provide a minimum level of service, even if to do so would be an undue financial burden...
-
§ 38.95(b)(5) Platform barriers
Each side of the lift platform which, in its raised position, extends beyond the car shall have a barrier a minimum 11/2 inches high....
-
1136A.1 Receptacle heights
Baseboard electrical outlets used in relocatable partitions, window walls or other electrical convenience floor outlets are not subject to the minimum height requirements. 4....
-
404.2.4.1 Swinging Doors and Gates
Table 404.2.4.1 Maneuvering Clearances at Manual Swinging Doors and Gates Type of Use Minimum Maneuvering Clearance Approach Direction...
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
Sites where either Test No. 1 or Test No. 3 is used and it is determined that an accessible route to the common (lobby) entrance is not required, a minimum of 20 percent of the ground floor...
-
11B-809.12 Electrical receptacles, controls and switches
controls and switches shall be located as follows: Where there is no obstruction, 48 inches (1219 mm) maximum measured from the top of the receptacle box and 15 inches (381 mm) minimum...
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
1011.2.1 Size and Location
Outdoor Constructed Feature Minimum Size and Location Picnic tables 36 inches (915 mm) on all usable sides of the table measured from...
-
Volume Control
Some commenters specifically recommended a minimum 25 decibels or greater....
-
1011.2.1 Size and Location
Table 1011.2.1 Clear Ground Space Outdoor Constructed Feature Minimum Size and Location Picnic tables 36 inches (915 mm) on all usable sides of...