Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
Search Results "Side Transfer Surface"
Filters
Commonly Searched Documents
-
11B-705.1.2.2 Curb ramps
-
407.12 Reach Height (Section-by-Section Analysis)
Specifically, this section would establish requirements for position (i.e., vertical reference plane), forward reach, and side reach....
-
Delta 4″ Centreset Faucet with Proximity™ Sensing Technology Hardwire 591TP0250
Product Features and Benefits Battery operated option available 3-hole installation 4" cast centreset, 5" long spout Proximity Sensing Technology Surface...
-
Construction and Maintenance Practices
Stagger speed humps to block only one lane at a time or limit them to the center of the road, leaving 32 inches (815 millimeters) of clear passage at each side....
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
Notes
AA For adjustable height chairs with footplates, as the height of the chair seat (transfer surface) moves up and down, the footplate moves up and down at the same time (i.e., with a fixed...
-
GRAB BAR
A grab bar may also provide support for a user transferring from a wheelchair onto a bench, seat or plumbing fixture. ◼...
-
12162(a)(3)(A)(i)(II)
(II) to fold and store wheelchairs (to accommodate individuals who wish to transfer to coach seats) equal to not less than one-half of the number of single-level rail passenger coaches in...
-
1133B.2.4.2
Regardless of the occupant load, there shall be a floor or landing on each side of a door. 1133B.2.4.2 Maneuvering clearances at doors. ...
-
11B-809.10.6.2 Slope
The floor surfaces shall be of Carborundum, grit-faced tile or of material providing equivalent slip resistance....
-
Alterations
Where play components are altered and the ground surface is not, the ground surface does not have to comply with the ASTM F 1951-99 standard for accessible surfaces unless the cost of providing...
-
TOTO® MS854114EL Commercial Eco UltraMax One-Piece Toilet ADA Height
one-piece design, this toilet features the quiet advantage of our powerful E-Max flushing system (see Smartfact below) and SanaGloss technology, an extraordinarily smooth, ion-barrier surface...
-
IV. ACCESSIBLE MEDICAL EQUIPMENT
from a wheelchair or other mobility device without slipping, and shall have a protective padded surface (unless such a surface is inconsistent with the table’s intended use)....
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-502.6.4.1
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
11B-502.6.4.1
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
What is slip resistance?
In fact, a truly non-slip surface could not be negotiated....
-
5. Conclusions
This study found that surface characteristics, more specifically surface roughness, can have a large impact on the WBVs that WC users are exposed to....
-
Zurn Insulation Combination Kit: One Trap Protector and Two Stop Supply Protectors
Combination Kit: One Trap Protector and Two Stop Supply Protectors FEATURES: Satin white PVC resin 3/8" Nominal wall with vandal resistant clips ADA compliant and resists thermal transfer...
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
-
Willoughby Industries 2235 Series AquaDeck Lavatory Deck
Willoughby AquaDeck Square front (3") solid surface lavatory Model No....
-
Clearances: ADA Standard Section 403.5
Section 403.5 covers the current ADA Standards for clearances on walking surfaces that are part of an accessible route.
-
Seat Location: ADA Standard Section 1009.2.2
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
