For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
Search Results "Minimum Dimension"
Filters
Commonly Searched Documents
-
307.2 Protrusion Limits
-
221.4 Designated Aisle Seats
Only when all seats on Aisle A would not meet the five percent minimum would seats on Aisle B be designated....
-
Facility
The tops of dining surfaces and work surfaces shall be 28 inches minimum and 34 inches maximum above the finish floor or ground....
-
T702.4 Character Height
Table T702.4—Character Height Sign location Minimum character height Exterior route or destination signs on boarding side of non-rail...
-
Ramp
The minimum length was 8 inches and the maximum length was 11 inches....
-
Is a transportation operator required to carry these “overweight” wheelchairs?
If a lift has the minimum design load of 600 pounds, there is no requirement for an agency to transport a heavier occupied device....
-
235.2.1 Dispersion
Where the minimum number of boat slips required to comply with 1003.3.1 has been met, no further dispersion shall be required. Advisory 235.2.1 Dispersion....
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
A4.5.3 Carpet
When both carpet and padding are used, it is desirable to have minimum movement (preferably none) between the floor and the pad and the pad and the carpet which would allow the carpet to...
-
Obstructions [4.7.8]
A landing with a minimum length of 48 inches will provide sufficient turning space....
-
Grab Bars [4.20.4] and Controls [4.20.5]
Recommendation: A hose for shower spray units longer than the required minimum of 60 inches is recommended for easier use of the shower spray unit from the seat....
-
F244.2 Camping Units with Mobility Features
This section requires camping facilities to provide a minimum number of camping units with mobility features based on the total number of camping units in accordance with Table 244.2....
-
Trailhead Signs
altered trails designed for use by hikers or pedestrians, the final rule requires the signs to include information on the length of the trail or trail segment; surface type; typical and minimum...
-
Accessible Theater Style
At a minimum, remove aisle chairs from the front, back and middle rows to create accessible seating locations....
-
1016.5 Obstacles
Where possible, obstacles that cross the full width of outdoor recreation access routes should be separated by a distance of 48 inches (1220 mm) minimum....
-
Assumptions
Playground surfaces selected for participation have documents indicating they have met the minimum specifications for ASTM F1292‒99/04 and ASTM F1951‒99 in a laboratory environment. 2...
-
1.1.16 Alternate measurement tools
If the F - number system is used ramps should have a minimum FF of 25....
-
1009.6.3 Size
Such wheelchair spaces shall not reduce the means of egress minimum width or required capacity....
-
§ 35.151(k)(2) Alterations to detention and correctional facilities.
correctional facilities shall comply with the 2010 Standards except that public entities shall provide accessible mobility features complying with section 807.2 of the 2010 Standards for a minimum...
-
810.5.3 Platform and Vehicle Floor Coordination--Modification to 810.5.3 of Appendix D to 36 CFR Part 1191
Low-level platforms shall be 8 inches (205 mm) minimum above top of rail....
-
11B-705.1.2.2 Curb ramps
Detectable warnings shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the line at the face of the curb marking the transition...