Self-test means any program, practice or study a lender voluntarily conducts or authorizes which is designed and used specifically to determine the extent or effectiveness of compliance...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
§100.141 Self-test
-
Tips for Recording Audio Materials
To the greatest extent possible, the recording should be done in a way that will allow the reader to easily locate individual chapters, sections, pages, etc., without having to listen to...
-
III-8.6000 Alternative means of dispute resolution
dispute resolution, including settlement negotiations, conciliation, facilitation, mediation, factfinding, minitrials, and arbitration to resolve disputes, where appropriate and to the extent...
-
11B-206.8 Security barriers
The accessible route shall permit persons with disabilities passing around security barriers to maintain visual contact with their personal items to the same extent provided others passing...
-
11B-206.8 Security barriers
The accessible route shall permit persons with disabilities passing around security barriers to maintain visual contact with their personal items to the same extent provided others passing...
-
206.8 Security Barriers
The accessible route shall permit persons with disabilities passing around security barriers to maintain visual contact with their personal items to the same extent provided others passing...
-
Sioux Chief DropKick™ Offset Flange 889-45PAM
Full-flow, 3" I.D. throat – no restriction Solvent welds inside 3" Sch. 40 fitting hub Corrosion-resistant 430 stainless steel swivel ring is engineered for maximum strength Black...
-
Sioux Chief FullFlush™ Offset Flange 889-AOM
½" offset in any direction for closet bowl setting Corrosion-resistant 430 stainless steel swivel ring is engineered for maximum strength Black...
-
Comparison of Transfer Protocols
The station used in phase 1 has a maximum height of 29 inches whereas the station used in phase 2 has a maximum of 43 inches....
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
11B-904.4.1 Parallel approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum above the finish floor shall be provided....
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-903.4 Back support
Back support shall be 48 inches (1219 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (457 mm) minimum above the seat...
-
Stages.
To the extent that such information cannot be quantified, the Department welcomes examples of personal or anecdotal experience that illustrate the value of this requirement....
-
Michael Silva
To provide compliance services for Architectural, Structural, Specialty Access Guidance (Reports and Implimentation), Expert Testimony and On-site coordination of construction related issues...
-
604 Water Closets and Toilet Compartments
ETA Editor's Note The text in this section references FSORAG section 6.6 for an exception related to Pit Toilets, however technical provisions for Pit Toilets are found in FSORAG section...
-
212 and 606 Kitchens, Kitchenettes, Lavatories, and Sinks
212 and 606 Kitchens, Kitchenettes, Lavatories, and Sinks The 1991 Standards, at sections 4.24, and 9.2.2(7), contain technical requirements for sinks and only have specific scoping requirements...
-
4.8.2* Slope and Rise
The maximum slope of a ramp in new construction shall be 1:12. The maximum rise for any run shall be 30 in (760 mm) (see Fig. 16)....
-
APPENDIX RESOURCES FOR LOCATING REASONABLE ACCOMMODATIONS
) the Interpretive Guidance accompanying the Title I regulations (also known as the "Appendix" to the regulations), 29 C.F.R. pt. 1630 app. .. 1630.2(o), (p), 1630.9 (1997) , and (2) A Technical...
-
Zurn Industries Trap Protector
Fits 1 1/2 [38] maximum, tubular and semi-cast P traps....
-
C. First Advance Notice of Proposed Rulemaking (2010)
Structure The 2010 ANPRM began with two separate introductory chapters. “508 Chapter 1: Application and Administration,” contained provisions preceded by the letter “E,” and included...
-
Ronald L. Mace Universal Design Institute
The Institute's work manifests the belief that all new environments and products, to the greatest extent possible, should and can be usable by everyone regardless of age, ability, or circumstance...
