[ADA Standards § 4.8.4] Yes No Note: if the running slope is less than 1:16 but more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing]....
Search Results "Enhanced 9-1-1"
-
f-v
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
4d.
[ADA Stds 4.8.4] Yes _____ No _____ Note: When the running slope is less than 1:16 and more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing....
-
6d. Ramp Length
[ADA Stds 4.8.4] Note: When the running slope is less than 1:16 and more than 1:20, each ramp segment may be up to 40 feet long followed by a level landing. Yes _____ No _____...
-
End of Document
Boente United States Attorney for the Eastern District of Virginia By: /s/ Steven Gordon Steven Gordon Assistant United States Attorney Date: 1/31/17 FOR...
-
1.1.4
1.1.4 A maximum overall design running slope for exterior accessible ramps of 7.5% (1:13.3 or 1:13) is recommended....
-
FTA Circular 4710.1: Americans with Disabilities Act Guidance
(Link is to PDF document online) November 4, 2015 Subject: AMERICANS WITH DISABILITIES ACT (ADA): GUIDANCE 1. PURPOSE....
-
Mockett PCS5/M/4E Large Rectangular Power Grommet
Perhaps best of all, it has a very low profile, just 1/8" above work surface. Fastens securely from underneath....
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
11B-604.7.1 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
Pilot Rock CN-R/D Trash Receptacle
Specifications: Model CN-R/D Trash Receptacle is fabricated from a single piece of 3/4-#9 expanded steel (diamond holes) and reinforced with 10 ga. top and bottom rings and die formed...
-
11B-604.5.2 Rear wall
Exceptions: 1. ...
-
404.3 Automatic and Power-Assisted Doors and Gates
Full-powered automatic doors shall comply with ANSI/BHMA A156.10 (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
Does the ADA prohibit discrimination by airlines?
Department of Transportation at 1-800-778-4838 (Voice) or 1-800-455-9880 (TTY) or visit airconsumer.ost.dot.gov/ACAAcomplaint.htm....
-
(d) Is regarded as having an impairment
(d) Is regarded as having an impairment means: (1) Has a physical or mental impairment that does not substantially limit major life activities but that is treated by a recipient as constituting...
-
Disability Discrimination
Weicker, Jr.1 1. Senator Lowell P. Weicker, Jr., statement, Cong. Rec., v.134 (April 28, 1988), p. S5107....
-
6.9 Tread Obstacles
Obstacles on beach access routes and their related resting intervals shall not exceed 1 inch (25 mm) in height measured vertically to the highest point....
-
16(d)
Franchised Hotel or Post-1993 Managed Hotel may opt to submit to the process set forth in this Paragraph 16 without regard to the occurrence of any event described in subparagraphs 16(a)(1)...
-
Ticket sales. (Section-by-Section Analysis)
In the NPRM, the Department proposed, in § 36.302(f)(1), a general rule that a public accommodation shall modify its policies, practices, or procedures to ensure that individuals with disabilities...
-
11B-1007.2 Accessible routes
Exceptions: 1. Playing surfaces shall not be required to comply with Section 11B-302.2 _|Carpet|_. 2. ...
-
505.6 Gripping Surface
Where provided, horizontal projections shall occur 1½ inches (38 mm) minimum below the bottom of the handrail gripping surface. [ECTCR UFAS 4.8.5(4), 4.9.4(4)] EXCEPTIONS: 1....
-
505.6 Gripping Surface
Where provided, horizontal projections shall occur 1½ inches (38 mm) minimum below the bottom of the handrail gripping surface. EXCEPTIONS: 1....
-
11B-505.6 Gripping surface
Where provided, horizontal projections shall occur 1½ inches (38 mm) minimum below the bottom of the handrail gripping surface. Exceptions: 1. ...
