Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 303.3 Beveled....
Search Results "Maximum Dimension"
Filters
Commonly Searched Documents
-
303.3 Beveled
-
§104.34(a) Academic setting
recipient to which this subpart applies shall educate, or shall provide for the education of, each qualified handicapped person in its jurisdiction with persons who are not handicapped to the maximum...
-
Cross Slope and Surfaces [4.8.6]
The cross slope (2% maximum) must be minimized because it makes wheelchair travel difficult by distributing more weight and required force to one side and causing front casters to veer....
-
Counters and Bars [5.2]
Types of Counters Maximum Height Minimum Length Knee Clearance (forward approach) Dining/Bars (service) 34 in 60 in required Dining/Bars...
-
Measuring Opening Force
Measuring Opening Force The maximum force pertains to the continuous application of force necessary to fully open a door, not the initial force needed to overcome the inertia of the door...
-
4.26.2* Size and Spacing of Grab Bars and Handrails
Handrails may be located in a recess if the recess is a maximum of 3 in (75 mm) deep and extends at least 18 in (455 mm) above the top of the rail (see Fig. 39(d))....
-
Clear Floor Space [4.25.2] and Height [4.25.3]
ADAAG specifies maximum reach heights according to the depth of reach....
-
6.7.1 Running Slope (Grade)
Running Slope (Grade) and Resting Intervals Running Slope (Grade) and Resting Intervals on Beach Access Routes Maximum Length of Segment Steeper than But not...
-
405.9 Edge Protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of 1/2 inch (13 mm) maximum within 10 inches (255 mm) horizontally of the minimum landing area...
-
1011.4 Picnic Tables
technical requirements for dining surfaces in 902.3 of the Architectural Barriers Act Accessibility Guidelines, which requires the tops of dining surfaces to be 28 inches minimum and 34 inches maximum...
-
Escalators
The referenced ASME criteria require steps to be demarcated by yellow lines 2” wide maximum along the back and sides (§6.1.3.5.6) and specify at least 2, but no more than 4, flat steps at...
-
M101.3 Equivalent Facilitation
., use of a patient lift) are not permitted because they do not provide for independent access to and use of diagnostic equipment by patients with disabilities to the maximum extent possible...
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab bar or seat so as to produce the maximum...
-
11B-603.5 Accessories
All operable parts, including coin slots, shall be 40 inches (1016 mm) maximum above the finish floor....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
11B-407.2.1.4 Location
Responding cars are programmed for maximum efficiency by reducing the number of stops any passenger experiences. ◼...
-
11B-1008.2.4.2 Elevated
Exceptions: The clear width of accessible routes connecting elevated play components shall be permitted to be reduced to 32 inches (813 mm) minimum for a distance of 24 inches (610 mm) maximum...
-
11B-603.5 Accessories
All operable parts, including coin slots, shall be 40 inches (1016 mm) maximum above the finish floor....
-
11B-809.10.7.1 Floor space
width may be reduced to 36 inches (914 mm) minimum for lavatories, cabinets, wing walls, or privacy walls located immediately adjacent to a water closet which extend 24 inches (610 mm) maximum...
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
2.0 Methodology
” and “minimum” reach while the U.S. standards have only one range delimited by a minimum and a maximum value....
-
Delta Single Handle Lavatory Faucet 551-DST
Includes matching finish drain assembly Meets standards set by Americans with Disabilities Act (ADA) 1.50 gpm @ 60 psi, 5.7 L/min @ 414 kPa 1 or 3-hole 4 in. installation Assembled dimensions...
-
Kompan, Inc. M7000 - Red House Playhouse
There is even a corner bench on the veranda that is big enough to allow an adult to join in the world of Let's Pretend, and the split level table on the outside gives an extra dimension...
