INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch maximum...
Search Results "Maximum Dimension"
-
Interior Routes
-
Interior Routes
INTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Carpet pile height 1/2 inch maximum...
-
Accessible Round Table Style
wheelchairs or other mobility aids will be seated at round tables, decrease the number of table settings by one or two to provide adequate space; for a five-foot round table set 8 places maximum...
-
1134A.5, Item 2
Grab bar reinforcement shall be installed on the back wall of the bathtub a maximum of 6 inches (152.4 mm) above the bathtub rim extending upward to at least 38 inches (965 mm) above the...
-
11B-405.2 Slope
Table 405.2 Maximum Ramp Slope and Rise for Existing Sites, Buildings, and Facilities Slope1 Maximum Rise Steeper than 1:10...
-
11B-405.2 Slope
Table 405.2 Maximum Ramp Slope and Rise for Existing Sites, Buildings, and Facilities Slope1 Maximum Rise Steeper than 1:10...
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
Those are usually the dimensions that can safely be considered industry tolerances. ...
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
The dimensions for dome size and dome spacing are the same as in the 2004 ADA and ABA Accessibility Guidelines....
-
3.3.5 Seat Height
3.3.5 Seat Height Height dimension standards for seats prescribed in the Australian, Canadian and U.S. standards were very similar (480 mm or 18.9 in., 480 mm or 18.9 in. and 485 mm...
-
Suggested accessibility guidelines for exterior concrete surfaces
However, the ACI standards do not permit interpolation or extrapolation for dimension greater than or less than 10 feet....
-
Areas for further work
Measurement instruments Accuracy of instruments/measurement uncertainty Use of significant figures Metric conversions or dual unit standards Measurement of dimensions...
-
2004 ADA and ABA Accessibility Guidelines
The Access Board is also considering additional technical criteria based on the 2004 ADA and ABA Accessibility Guidelines for cross section dimensions and clearances around gripping surfaces...
-
5.2.1.1 Transfer Surface Width Recommendations for M301
Some supported the 28-inch dimension noting there is little gain in usability by increasing the transfer surface width to 30....
-
The Target Population
For many dimensions women represent the smaller end of the distribution....
-
DORMA ED700 Low-Energy Swing Door Operator
The ED700 may be used for door widths up to 48" (1220 mm) and a maximum weight of 200 lb (91 kg)....
-
BEA Inc. High/Low Mount Boxes Bronze Bollards
Dimensions: 42” (106.68 cm) x 6” (15.24 cm) x 4” (10.16 cm): Mounting: Surface mount or attached to single/double gang, or 4x4 electrical box (All on face of bollard post)...
-
NOTES
[and] to a position low enough [19 inches maximum] to allow for the comfort of providers who choose to work in a seated position, to enable patients to keep their feet on the floor while...
-
T504 Fare Collection Devices
A transit agency expressed concern that application of the requirements in this section, in conjunction with the maximum mounting height for operable parts specified in T304 (i.e., operable...
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
1132A.4 Level floor or landing
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 4 inches (101.6 mm)....
-
4. Passenger Information
For instance, this final rule requires carriers through their reservation agents to inform passengers of the maximum weight and dimensions of a device that can be accommodated in the aircraft...
-
11B-239.2 Minimum number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
-
239.2 Minimum Number
If a course is designed with the minimum 50 percent accessible holes, designers or operators are encouraged to select holes which provide for an equivalent experience to the maximum extent...
-
233.3.6
233.3.6 All new single-family houses, duplexes, triplexes, condominiums, and townhouses shall provide at least one bathroom, located with maximum possible privacy, where bathrooms are provided...
