pedestrians, the final rule requires the signs to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and maximum running slope...
Search Results "Floor Slope"
Filters
Commonly Searched Documents
-
Trailhead Signs
-
Existing Site Constraints: ADA Standard Section 206.7.5
Section 206.5.1 covers scoping requirements in the most current ADA Standards for the use of platform lifts due to existing site constraints.
-
11B-904.4.2 Forward approach
A clear floor or ground space complying with Section 11B-305 shall be positioned for a forward approach to the counter. [2010 ADA Standards] 904.4.2 Forward Approach....
-
11B-406.5.6 Grade breaks
Surface slopes that meet at grade breaks shall be flush....
-
D5
[ADA Standards §§ 4.1.6(3)(d)(ii), 4.13.8] Yes No If No, replace threshold with one with beveled sides or add a sloped insert....
-
M5
[ADA Standards §§ 4.1.6(3)(d)(ii); 4.13.8] Yes No If No, replace threshold with one with beveled sides or add a sloped insert....
-
11B-406.5.6 Grade breaks
Surface slopes that meet at grade breaks shall be flush....
-
11B-406.5.6 Grade breaks
Surface slopes that meet at grade breaks shall be flush....
-
11B-705.1.2.2.2.1 One entrance/exit point
Where the turning space has one entrance/exit point other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep, as measured perpendicular to the curb, and...
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [Safe Harbor only applies to existing curb ramps in the vicinity of, and leading to, a primary entrance.]...
-
Behavioral Safety Products #FV600 Ligature Resistant Flush Valve Cover
It has a sloped top with rounded edges and corners and can be easily field cut to fit varying flush valve dimensions....
-
Seating Solutions ADA Platforms, Ramps & Stairs
manufacturing allows us to build to your exact requirements Modular designs allow us to build around obstacles on site All aluminum construction Code compliant 1:12 slope...
-
FIGURE INDEX
in Level Figure 303.3 Beveled Change in Level Figure 304.3.2 T-Shaped Turning Space Figure 305.3 Clear Floor or Ground Space Figure 305.5 Position of Clear Floor or Ground...
-
4(4)
Thresholds and changes in level at these locations are beveled with a slope no greater than 1:2....
-
H5
[ADA Standards §§ 4.1.6(3)(d)(ii), 4.13.8] Yes No NA If No, replace threshold with one with beveled sides or add a sloped insert....
-
D5. Raised Threshold
[ADA Stds 4.1.6(3)(d)(ii), 4.13.8] Yes _____ No _____ If No, replace threshold with one with beveled sides or add sloped insert to threshold....
-
General: ADA Standard Section 306.3.1
Section 306.3.1 of the ADA Standards covers information in the current ADA Standards for knee clearance.
-
11B-813.2.6 Shelf
No fewer than one shelf shall be provided in close proximity to the changing table at 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....
-
Door and Gate Surfaces: ADA Standard Section 404.2.10
Section 404.2.10 covers the current ADA Standards for door and gate surfaces on manual doors and gates.
-
11B-809.10.7.3 Reinforcement for grab bars
comply with the following: Where water closets are not placed adjacent to a side wall capable of accommodating a grab bar, the bathroom shall have provisions for installation of floor-mounted...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
403.6 Handrails
Where handrails are provided along walking surfaces with running slopes not steeper than 1:20 they shall comply with 505. Advisory 403.6 Handrails....
-
1009.2.2 Seat Location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
