Section 242.3 of the 2004 ADAAG provides that newly constructed or altered wading pools must provide at least one sloped means of entry to the deepest part of the pool. ...
Search Results "Floor Slope"
-
Wading pools. (Section-by-Section Analysis)
-
11B-809.8 Doors
The floor or landing at primary entry doors, required exit doors, and secondary exit doors where a change in elevation occurs between the interior and the exterior surface of the floor or...
-
RAMP
A walking surface that has a running slope steeper than one unit vertical in 20 units horizontal (5-percent slope)....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [2010 ADA Standards] 406.4 Landings. Landings shall be provided at the tops of curb ramps....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [2010 ADA Standards] 406.4 Landings. Landings shall be provided at the tops of curb ramps....
- American Standard Stallbrook Urinal
- Face® Dipstick® Profiler Precise, Accurate & Repeatable (Concrete/Pavement Flatness & Levelness)
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
Transfer Space: ADA Standard Section 1009.5.2
A transfer space of 60 inches (1525 mm) minimum by 60 inches (1525 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
-
11B-1009.5.2 Transfer space
A transfer space of 60 inches (1524 mm) minimum by 60 inches (1524 mm) minimum with a slope not steeper than 1:48 shall be provided at the base of the transfer platform surface and shall...
- ADA Checklist for Existing Facilities
-
Minimum Rear Wall Required.
Using the 2010 ADA Standards for Accessible Design, the minimum bench length would be 42" and the width of the clear floor space adjacent to the end of the bench would be 30"....
-
Existing elevator cab size
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Question: Alteration vs. Maintenance for Stairs in Pre-ADA Building
The site in question is a large, pre-ADA building with retail on the ground floor and offices (not public accomodations) on the second floor....
- SmartCells Flooring: Softer Anti-Fatigue Mats are NOT Better
-
Blended Transitions (R304.4) (Section-by-Section Analysis)
Blended Transitions (R304.4) (Section-by-Section Analysis) A maximum running slope of 5 percent is specified for blended transitions....
-
Outdoor Rinsing Showers
Both showers must meet the clear floor and ground space and outdoor recreation access route requirements that follow....
-
Accessible Routes
Technical provisions address the width, slope, and surface of both ground level and elevated accessible routes....
-
4.9.4 HANDRAILS
At the top, the extension shall be parallel with the floor or ground surface....
-
11B-406.3 Parallel curb ramps
A parallel curb ramp may be provided with one sloping segment or two opposing sloping segments....
-
What surface characteristics are required of an accessible route?
The Americans with Disabilities Act Accessibility Guidelines (ADAAG) requires only that newly-constructed or altered ground and floor surfaces of accessible routes on sites and in buildings...
-
Story
That portion of a building or facility designed for human occupancy included between the upper surface of a floor and upper surface of the floor or roof next above....