Beginning in January 2014, the California Building Code (Chapter 11B-309.4) established a 5 lb. maximum force on operational hardware, including—for the first time—panic hardware....
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
Allegion Von Duprin 98/99 Series AX Intro Video
-
Easterseals Superior California
Our Mission Easterseals Superior California is dedicated to empowering people with disabilities by offering a wide range of services and leadership opportunities designed to encourage maximum...
-
Jackson Center for Independent Living (JCIL) - Jackson, TN
The Jackson Center for Independent Living is a community based, nonresidential, consumer controlled program of services designed to enable persons with disabilities to achieve maximum independence...
-
Accessible Fishing Piers and Platforms
ADAAG addresses only the built environment (structures and grounds). The guidelines do not address operational issues....
-
Maintenance (Trail Terminology)
dips or culverts, and realigning sections of trail to prevent erosion or to avoid boggy areas Repairing or replacing deteriorated, damaged, or vandalized trail or trailhead structures...
-
12206(c)(1) Rendering assistance
(1) Rendering assistance Each Federal agency that has responsibility under paragraph (2) for implementing this chapter may render technical assistance to individuals and institutions...
-
§ 36.304(d)(2)(i)
Elements that have not been altered in existing facilities on or after March 15, 2012 and that comply with the corresponding technical and scoping specifications for those elements in the...
-
9(1)
(1) Except as specified in the special technical provisions of this section, accessible transient lodging shall comply with the applicable requirements of 4.1 through 4.35....
-
What Makes Removal of a Barrier "Readily Achievable"?
Click here to view PDF version of this document (0.88 MB) The following paragraphs are taken, verbatim, from the Americans with Disabilities Act and the implementing Regulations and Technical...
-
609.2.2 Non-Circular Cross Section
Grab bars with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches (120 mm)...
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
505.7.2 Non-Circular Cross Sections
Handrail gripping surfaces with a non-circular cross section shall have a perimeter dimension of 4 inches (100 mm) minimum and 6¼ inches (160 mm) maximum, and a cross-section dimension of...
-
T302.4 Surface Discontinuities
Surface discontinuities shall be ½ inch (13 mm) high maximum and shall be beveled with a slope not steeper than 1:2. EXCEPTIONS: 1....
-
705.1.1 Dome Size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...
-
Perpendicular Curb Ramps (R304.2) (Section-by-Section Analysis)
A maximum slope of 10 percent is specified for the flared sides of perpendicular curb ramps where a pedestrian circulation path crosses the curb ramp....
-
11B-604.2 Location
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
208.1 General
See section 502.5 requirements for van parking in structures....
-
BACKGROUND
The purpose of these code requirements is to ensure that barrier-free design is incorporated in all buildings, facilities, site work, additions, alterations, and structural repairs....
-
11B-307.3 Post-mounted objects
Free-standing objects mounted on posts or pylons shall overhang circulation paths 12 inches (305 mm) maximum when located 27 inches (686 mm) minimum and 80 inches (2032 mm) maximum above...
-
407.12.3.2 Obstructed Forward Reach (Section-by-Section Analysis)
407.12.3.2 Obstructed Forward Reach (Section-by-Section Analysis) This section proposes that, where an obstructed forward reach is provided, the maximum allowable forward reach to an...
-
307.3 Post-Mounted Objects
Free-standing objects mounted on posts or pylons shall overhang circulation paths 12 inches (305 mm) maximum when located 27 inches (685 mm) minimum and 80 inches (2030 mm) maximum above...
-
R402.3 Post-Mounted Objects
Where objects are mounted on free-standing posts or pylons and the objects are 685 mm (2.25 ft) minimum and 2030 mm (6.7 ft) maximum above the finish surface, the objects shall overhang...
-
Accessible - Changes in Level
The maximum slope of a ramp in new construction shall be no greater than 1;12....
-
11B-603.4 Coat hooks, shelves and medicine cabinets
Shelves shall be located 40 inches (1016 mm) minimum and 48 inches (1219 mm) maximum above the finish floor....
