Toe clearance shall be 30 inches (762 mm) wide minimum.
Search Results "Seat Width"
-
11B-306.2.5 Width
-
11B-306.2.5 Width
Toe clearance shall be 30 inches (762 mm) wide minimum.
-
11B-503.3.1 Width
Access aisles serving vehicle pull-up spaces shall be 60 inches (1524 mm) wide minimum.
-
11B-503.3.1 Width
Access aisles serving vehicle pull-up spaces shall be 60 inches (1524 mm) wide minimum.
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
Re: Stair widths
I don't think this is a contradiction, just a higher standard for stairs which need to meet requirements for stairs which are considered part of the accessible means of egress. The...
-
1133A.2.1 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, countertop or the face of any appliance (excluding handles and controls) that projects into the kitchen and the opposing...
-
1133A.2.1 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, countertop or the face of any appliance (excluding handles and controls) that projects into the kitchen and the opposing...
-
17 Inch Low Height
The safest and most easily accessible transfers are those with no or very little horizontal and vertical distance between the seat of the wheelchair and the transfer surface....
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
11B-1002.4.4.1 Width and length
Wheelchair spaces shall provide a clear width of 30 inches (762 mm) minimum and a clear length of 48 inches (1219 mm) minimum measured to 9 inches (229 mm) minimum above the floor surface...
-
Chapter 3: Study findings
[See subsections ...]
-
4.34.5.4 BATHTUBS
If a bathtub is provided, then it shall have the following features:
-
§ 38.125(d) Seating
(d) Seating—...
- Midmark Ritter 223 Barrier-Free® Power Examination Table
- Midmark Ritter 222 Barrier-Free® Power Examination Table
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
gripping surface would be appropriate for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
M305.2.2 Length (Section-by-Section Analysis)
inches deep, the Committee recommended requiring a transfer support to extend horizontally along the side of the patient table at the designated transfer location for at least the minimum width...
-
Requirement 6. Reinforced walls for grab bars.
that all premises within covered multifamily dwelling units contain reinforcements in bathroom walls to allow later installation of grab bars around toilet, tub, shower stall and shower seat...
-
221.2.1.1 General Seating
221.2.1.1 General Seating. Wheelchair spaces complying with 802.1 shall be provided in accordance with Table 221.2.1.1....
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
Section C: Exterior Route
Ward:__________ Precinct:__________ Staff:________________ Date:________ Time:_________ Address:_______________________________________ Location...