Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
604.9.6 Dispensers
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
Check-out Aisle Counter Height
The counter surface of check-out aisle counters is required to be 38 inches high maximum. Comments from persons with disabilities considered 38 inches to be too high. Response....
-
608.5.1 Transfer Type Shower Compartments
transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm) maximum...
-
602.2 Clear Floor Space
EXCEPTION: A parallel approach complying with 305 shall be permitted at units for children’s use where the spout is 30 inches (760 mm) maximum above the finish floor or ground and is 3½...
-
11B-602.2 Clear floor space
Exception: A parallel approach complying with Section 11B-305 shall be permitted at units for children's use where the spout is 30 inches (762 mm) maximum above the finish floor or ground...
-
608.5.1 Transfer Type Shower Compartments
transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm) maximum...
-
10.2.1(3)
In addition, to the maximum extent practicable, all new bus route identification signs shall comply with 4.30.2 and 4.30.3....
-
1.1.5
1.1.5 A maximum design cross slope for accessible exterior pedestrian paving and ramps of 1.5% (1:67 or about 3/16 in. per ft. [15 mm per m]) is recommended....
-
11B-602.2 Clear floor space
Exception: A parallel approach complying with Section 11B-305 shall be permitted at units for children's use where the spout is 30 inches (762 mm) maximum above the finish floor or ground...
-
Häfele America Co. Soap Dispenser Stainless Steel
Mounting hardware for drywall construction must be ordered separately Capacity (20 oz) 0.6 l Width (3 3/4") 95 mm Height (10 13/16") 275 mm Depth...
-
Häfele America Co. Paper Towel Waste Bin Wall Mounted
Product details: Model series 805 Capacity (26.5 quarts) 25 liters Depth (6 5/16") 160 mm Width (11 13...
-
Boolee Multi-Station Voting Booth
Twin With ADA Compliant Station Height: 60" Depth: 24" Width: 59" Tables: 18x25.5" 18x29" Table Heights: 39.5 - 32.5" Folded Width: 7.0" Weight: 22 lbs...
-
4.13.11* Door Opening Force
The maximum force for pushing or pulling open a door shall be as follows:...
-
Jean Tessmer
Meets all ADA reach and operability requirements, They also sell the track system....
-
Re: Service Counters
For code compliance, one must create a reasonable standard for sufficient depth for accessible use. Reasonable persons will disagree on that number. Why bother? ...
-
228 Depositories, Vending Machines, Change Machines, and Mail Boxes
Gas pump manufacturers expressed concerns about reach range requirements and operating force specifications which have been addressed in the final rule, as discussed in sections 308 and...
-
Transfer Height
If multiple transfers are necessary to reach the amusement ride seat, it is recommended that each vertical transfer not exceed 8 inches....
-
B. PRELIMINARY ISSUES
Before reaching the question of whether Kirola has Article III standing, the Court addresses four preliminary contentions concerning the constellation of evidence which may be considered...
-
c-ii
If No, then either provide back-up electrical power to operate the lift or elevator during the power outage or locate shelter services exclusively on accessible levels that may be reached...
-
2.3.1 Standards
When the NYS standards were drafted in l988‒89, the manufacturers could not reach a consensus regarding minimum energy level of the IR light at a set distance from the emitters....
-
M305.2.2 Length (Section-by-Section Analysis)
there was no requirement for length of the transfer support; however, the MDE NPRM preamble noted that the Access Board was considering requiring the transfer supports to extend the entire depth...
-
AVAILABLE DATA DO NOT SUPPORT DEPARTING FROM THE CURRENTLY ACCEPTED STANDARD OF 19-INCH TRANSFER SURFACE HEIGHT
The most important illustrations for present purposes are "seat plane angle," "effective seat depth," and "seat surface height at the front edge."...
-
Moisture and Durability
The trendline fitted to the data of the moisture profile in E2 indicates that it is saturated at a depth of approximately 100 mm (4”) and continues to be saturated to the drainage bed....
