Maximum effort to operate doors shall not exceed 8½ pounds (38 N) for exterior doors and 5 pounds (22 N) for interior doors, such pull or push effort being applied at right angles to hinged...
Search Results "Maximum Reach Depth"
Commonly Searched Documents
-
1132A.6 Closer-effort to operate doors
-
1132A.6 Closer-effort to operate doors
Maximum effort to operate doors shall not exceed 8½ pounds (38 N) for exterior doors and 5 pounds (22 N) for interior doors, such pull or push effort being applied at right angles to hinged...
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-604.9.1 Location
The centerline of the water closet shall be 12 inches (305 mm) minimum and 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
- Innerface Clearview Interior Signage
- Bobrick ClassicSeries Recessed Sanitary Napkin Disposal and Toilet Tissue Dispenser B-3094
- Delta Single Handle Centerset Lavatory Faucet 520-DST
- Bobrick ClassicSeries Recessed Paper Towel Dispenser B-359
- Bobrick TrimLineSeries Recessed Paper Towel Dispenser/Waste Receptacle B-36903
- Delta Single Handle Centerset Lavatory Faucet 500-DST
- Bobrick ClassicSeries Recessed Paper Towel Dispenser/Waste Receptacle B-369
-
Transfer Devices for Use with Amusement Rides: ADA Standard Section 1002.6
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm)....
-
11B-1002.6 Transfer devices for use with amusement rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm). ◼...
- Sioux Chief DropKick™ Offset Flange 889-45PAM
- Sioux Chief FullFlush™ Offset Flange 889-AOM
-
1008.3.2.2 Height
Each transfer step shall be 8 inches (205 mm) high maximum....
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical....
-
405.6 Rise
The rise for any ramp run shall be 30 inches (760 mm) maximum....
-
1008.3.2.2 Height
Each transfer step shall be 8 inches (205 mm) high maximum....
-
405.6 Rise
The rise for any ramp run shall be 30 inches (760 mm) maximum....
-
R407.6.1 Slope
Landing slopes shall be 2 percent maximum in any direction....
-
11B-405.6 Rise
The rise for any ramp run shall be 30 inches (762 mm) maximum....
-
11B-406.5.7 Cross slope
The cross slope of curb ramps and blended transitions shall be 1:48 maximum....