Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is a minimum of 9 inches above the floor, and may overlap a maximum of 19...
Search Results "Maximum Reach Depth"
Commonly Searched Documents
-
§ 38.107(a)(1)
-
§ 38.123(a)(1)
Permanently installed fixtures may overlap this area a maximum of 6 inches, if the lowest portion of the fixture is a minimum of 9 inches above the floor, and may overlap a maximum of 19...
-
Impact Annenuation [sic]
G 56 83 60 87 312 313 324 318 H 65 103 69 101 325 493 406 472 The specification calls for a maximum...
-
602.4 Spout Height
Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground....
-
602.4 Spout Height
Spout outlets shall be 36 inches (915 mm) maximum above the finish floor or ground....
-
R407.5 Rise
The rise for any ramp run shall be 760 mm (2.5 ft) maximum....
-
405.6 Rise
The rise for any ramp run shall be 30 inches (760 mm) maximum....
-
1008.3.2.2 Height
Each transfer step shall be 8 inches (205 mm) high maximum....
-
11B-602.4 Spout height
Spout outlets shall be 36 inches (914 mm) maximum above the finish floor or ground....
-
303.2 Vertical
Changes in level of 1/4 inch (6.4 mm) high maximum shall be permitted to be vertical....
-
4.1.6(3)(a)(i)
(i) A slope between 1:10 and 1:12 is allowed for a maximum rise of 6 inches....
-
11B-602.4 Spout height
Spout outlets shall be 36 inches (914 mm) maximum above the finish floor or ground....
- Panda IS.14 All Aluminum IMPACT Lift & Slide System
- Panda TS.87 Thermally Broken Slim Profile Lift & Slide System
-
Re: Service Counters
Providing the full 2'6'' depth at the lower counter would provide an equal sized counter but I could argue that 18'' deep would also work....
-
702 Fire Alarm Systems
However, the Board had proposed a lower maximum sound level for audible alarms (110 decibels instead of 120 decibels) as more appropriate and to guard against tinnitus. Comment....
-
Shower Threshold
The proposed rule specified a maximum threshold height of ½ inch, provided that those greater than ¼ inch are beveled with a slope of 1:2 maximum (608.7)....
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
M101.1 Purpose (Section-by-Section Analysis)
diagnostic equipment that is accessible to and usable by patients with disabilities and to provide patients with disabilities independent access to and use of diagnostic equipment to the maximum...
-
1007.2 Accessible Routes
Where accessible routes intersect playing surfaces of holes, a 1 inch (25 mm) maximum curb shall be permitted for a width of 32 inches (815 mm) minimum. 3....
-
11B-504.5 Nosings
The radius of curvature at the leading edge of the tread shall be ½ inch (12.7 mm) maximum....
-
11B-504.5 Nosings
The radius of curvature at the leading edge of the tread shall be ½ inch (12.7 mm) maximum....
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
11B-504.5 Nosings
The radius of curvature at the leading edge of the tread shall be ½ inch (12.7 mm) maximum....