SEAT HEIGHT MEASUREMENT DETAIL Regardless of measurement technique used, the height is measured at the highest point of the seat, inclusive of bolsters, with the foam in an uncompressed...
Search Results "Seat Designation"
Commonly Searched Documents
-
SEAT HEIGHT MEASUREMENT DETAIL
-
11B-407.4.7 Designations and indicators of car controls
Designations and indicators of car controls shall comply with Section 11B-407.4.7....
-
§ 36.308 Seating in assembly areas
§ 36.308 Seating in assembly areas....
-
104.11 Alternative materials, design and methods of construction and equipment
The provisions of this code are not intended to prevent the installation of any material or to prohibit any design or method of construction not specifically prescribed by this code, provided...
-
221.2.1.1 General Seating
Number of Wheelchair Spaces in Assembly Areas Number of Seats Minimum Number of Required Wheelchair Spaces 4 to 25...
- Brewer AssistPRO™ Power Procedure Table
- Brewer Assist Power Procedure Table
-
DSA IR 11B-4: DETECTABLE WARNINGS (with revisions issued through Nov. 2011)
This IR indicates an acceptable method for achieving compliance with applicable codes and regulations, although other methods proposed by design professionals may be considered by DSA....
- Access Board: Single User Toilet Room Size and Layout
-
4.1.2 Surface Design of Examination Tables and Chairs
4.1.2 Surface Design of Examination Tables and Chairs For several reasons including patient comfort and safety, the surfaces of many examination tables and chairs are not flat....
-
F221.2.1.1 General Seating
[ECTCR UFAS 4.1.2(18)(a) depending on assembly size] Table F221.2.1.1 Number of Wheelchair Spaces in Assembly Areas Number of Seats Minimum Number of Required Wheelchair...
-
Gripping Surface Cross Section and Clearances M301, M302, and M305.2
Gripping Surface Cross Section and Clearances M301, M302, and M305.2 Gripping surface for transfer supports shall be free of sharp or abrasive elements and shall have rounded...
- Designing Activities in Proloquo2Go 4
-
Attachment I: Program Access in Existing Facilities
Attachment I: Program Access in Existing Facilities
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
11B-1002.4.7.1 Shoulder-to-shoulder seating
Where an amusement ride provides shoulder-to-shoulder seating, companion seats shall be shoulder-to-shoulder with the adjacent wheelchair space....
-
11B-1002.4.7.1 Shoulder-to-shoulder seating
Where an amusement ride provides shoulder-to-shoulder seating, companion seats shall be shoulder-to-shoulder with the adjacent wheelchair space....
-
11B-411.4.7 Designations and indicators of car control buttons
Designations and indicators of car control buttons shall comply with Section 11B-411.4.7....
- American Standard AquaWash Telescoping Bidet Seat 5900A.05G
-
EXPLANATION OF STUDY DESIGN
EXPLANATION OF STUDY DESIGN...
-
Bathroom Design Illustrations
Other commenters stated that the Department's bathroom design illustrations at 55 FR 24374-24375 are not consistent with the Figure 8 bathroom design illustrations at 55 FR 24401....
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater Video
-
T402.2 Design Load
Ramps and bridgeplates 30 inches (760 mm) or more in length shall be designed to support a load of 600 pounds (273 kg) minimum, placed at the centroid of the ramp distributed over an area...