Features + Benefits: Easy installation requiring no special tools Long-lasting polyethylene SuperDeck pays for itself in maintenance savings Three deck and float widths...
Search Results "Stroke Width"
Filters
Commonly Searched Documents
-
SuperDeck Beach Boardwalk
-
Inpro Corporation JointMaster® 103 Series-VCT Expansion Joint Systems
assembly Standard loading capabilities Aluminum mill finish Key Specifications Floor/Floor, Floor/Wall Conditions Movement: +/- 25% Joint width...
-
Hussey Seating Company Roll-A-Way Seating
Available in 2-chair (approx. 46”/1168 mm) or 3-chair (approx. 66”/1676mm) widths to accommodate one or two wheelchairs. Adjacent companion chairs can be permanently installed....
-
SafePath EZCurb™ Wheelchair Ramps - Vertical Barrier Removal
Standard widths are 60" wide and are available from 2" to 6" in height....
-
Inpro Corporation JointMaster® 101 Series Floor Expansion Joint Covers
Mill finish aluminum Integral vapor barrier option available Key Specifications: Floor/Floor, Floor/Wall Conditions Movement: +/- 25% Joint width...
-
Healthcraft Invisia ADA Serenaseat™ Folding Shower Seat
The seating surface shall be 32"/81cm in width. Product back rest shall be removable. Product shall fold up against the wall with a profile of less than 3"/7.5cm....
-
Midmark 630 HUMANFORM™ Procedures Table
Height: Minimum 18" (45.7 cm), Maximum 40" (101.6 cm) Seat Tilt Angle Range: 0 ̊ to 30 ̊ Back Support Angle Range: 0 ̊ to 80 ̊ Foot Support Angle Range:0 ̊ to 90 ̊ 28" Upholstery Width...
-
Comparison of Single-User Toilet Room Layouts: 1A, 1B, and 1C
The size of this space is determined by the minimum width required for the water closet and lavatory between the side walls, the minimum wheelchair turning space, and the space required...
-
Ramps
They must meet the ADA's requirements regarding slope, width, landings, handrails, and edge protection....
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
M302.2.4 Transfer Sides (Section-by-Section Analysis)
diagnostic equipment used by patients in the seated position required transfer surfaces to have the option to transfer from a mobility device onto one short side (depth) and one long side (width...
-
2. Shared Use Paths
rights-of-way guidelines, which address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width...
-
2. Shared Use Paths
rights-of-way guidelines, which address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Accessible Routes on the Playing Surface
The orientation of the length and the width have not been specified for added flexibility in design. Slopes on landings must be no more than 1:20 (5%)....
-
Alternative Golf Car Passage
A golf car passage can be substituted for all or part of the accessible route connecting elements within the boundary of the course and must be a minimum of 48 inches in width....
-
5.9.2.1 Standing Supports on Single Ramped Entry Raised Platforms with Wheelchair Spaces Recommendations
A 34-inch minimum width between the supports will allow for adequate elbow space for a user of a wheeled mobility device to push the wheels onto the platform and does not infringe on the...
-
Distinct Viewing Locations [F246.2, 1015.2, and 1015.3]
The viewing space must be free and clear of obstructions between 32 and 51 inches above the ground and must extend the full width of the clear ground space....
-
C) Accessible Entrance
The clear width of the opening must be at least 32 inches wide and accessible door hardware (handle and latch) must be provided....
-
2. Shared Use Paths
rights-of-way guidelines, which address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width...
-
The Purpose of FSORAG and FSTAG
trail is included (scoping); what has to comply with the guidelines; definitions of terms; and technical requirements defining the physical characteristics of accessible features, such as width...
-
3.3.13 360-Degree Turn
* indicates data plotted in the graph Figure 3-13. 360-degree turning width area: research findings versus the standards....
-
1.1.17 Stairs
For stairs 60 in. (1520 mm) or less in width, measure along a line approximately 18 in. (460 mm) from the wall or outside edge of the stair....
-
2. Shared Use Paths
rights-of-way guidelines, which address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width...
