The Department wishes to clarify that measures taken as alternatives to barrier removal, such as retrieving items from shelves or providing curb service or home delivery, are not to be considered...
Search Results "Mitigating Measures"
Filters
Commonly Searched Documents
-
Section 36.306 Personal Devices and Services (Preamble, Section-by-Section Analysis)
-
Examples of Contractor Cases
However, his own doctor provided evidence of much lower readings, based on measurements of his blood pressure at several times during a physical exam....
-
A. About Appendices 1 and 2
Surveyors should refer to the instructions the first time they use a form and as often as needed to make sure they are taking the required measurements and answering the questions correctly...
-
a. Transfer Surface Adjustability
in the seated position: an adjustable transfer height range with a minimum high and low height; four intermediate transfer heights within the adjustable range; and a specific method to measure...
-
Picnic Tables [1011.2 and 1011.4]
The clear ground space is measured from the back edge of the benches....
-
6. Modifications to the Functional Performance Criterion for Limited Vision
In response to these comments, in the 2011 ANPRM, the Access Board dispensed with specified measurements of visual acuity and relied instead on a functional approach reflective of the needs...
-
Cost Estimates for Barrier Removal
reviews Environmental or Hazardous Materials removal Seismic upgrade requirements triggered by barrier removal Energy conservation measures...
-
Background
Advisory information in the guidelines discusses the use of a Rotational Penetrometer to measure the firmness and stability of surfaces that are located on trails. According to U.S....
-
Introduction
Successful accessibility is often measured in inches, so attention to detail can make the difference between achieving access and excluding or injuring someone....
-
11B-604.3.2 Overlap
with Section 11B-606 shall be permitted on the rear wall 18 inches (457 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1676 mm) minimum measured...
-
11B-604.3.2 Overlap
rear wall 26 inches (660 mm) minimum from the water closet centerline to allow for the installation of a grab bar where the clearance at the water closet is 66 inches (1676 mm) minimum measured...
-
Clarification on Standard Roll-In Shower Compliance
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
T103 Definitions
One transit agency described the term as serving as a “reliable measure” for transit operators....
-
Database Development
These reach distances were measured in 3-D at five normalized shelf heights in three different directions (lateral, forward and an intermediate 45 degrees) resulting in 15 reach data points...
-
Detecto 6550 Portable Wheelchair Scale
Platform measures 30 x 32 inch (76 x 81 cm). EMR/EHR ready. 1,000 lb x 0.2 lb / 450 kg x 0.1 kg capacity. OIML EC Class III model available....
-
Stages.
Question 4: The Department welcomes comment on how to measure or quantify the intangible benefits that would accrue from accessible witness stands....
-
Test A (Section-by-Section Analysis)
The question of whether a person has a disability should be assessed without regard to the availability of mitigating measures, such as reasonable modifications or auxiliary aids and services...
-
Play areas. (Section-by-Section Analysis)
The Department is proposing several specific provisions and posing additional questions in an effort to both mitigate and gather information about the potential burden of the supplemental...
-
"Readily achievable.'' (Preamble, Section-by-Section Analysis)
The Department believes that legitimate safety requirements, including crime prevention measures, may be taken into account so long as they are based on actual risks and are necessary for...
-
Section 35.151(b) Alterations (Section-by-Section Analysis)
The Department's proposed rule would amend § 35.151(b)(2) to make clear that the path of travel requirements of § 35.151(b)(4) do not apply to measures taken solely to comply with program...
-
Links
accessibility/ Forest Service Trail Accessibility Guidelines http://www.fs.fed.us/recreation/programs/accessibility/ Forest Service Trail Design Parameters http://www.fs.fed.us/r3/measures...
-
Background
Tests were performed at regular intervals to provide a quantitative measure of accessibility and impact attenuation. An impact test was performed after the 6-month exposure period....
-
References
Measuring leisure satisfaction. Journal of Leisure Research, 12(1), 20-33. Beard, J. G., & Ragheb, M. G. (1983). Measuring leisure motivation....
-
Standing Supports (M304.3 and M305.3)
Tilley, The Measure of Man & Woman: Human Factors in Design, (New York, John Wiley and Sons, 2002), page 43....
