Whether or not any of these measures is readily achievable is to be determined on a case- by-case basis in light of the particular circumstances presented and the factors discussed above...
Search Results "Mitigating Measures"
-
What barriers will it be "readily achievable" to remove?
-
Wheeled Mobility Anthropometry Project
The Access Board and the National Institute on Disability and Rehabilitation Research sponsored a Wheeled Mobility Anthropometry Project to collect measurements of approximately 500 people...
-
P. MAINTENANCE OF ACCESSIBLE FEATURES AND TRAINING
The report will include the ILA certifications received pursuant to paragraphs 16 through 18 of this Consent Decree, photographs showing measurements, architectural plans, notices published...
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
11B-703.5.5 Character height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
D. Technical standards for construct validity studies
A selection procedure should then be identified or developed which measures the construct identified in accord with subparagraph (2) above....
-
Section 1630.11 Administration of Tests
This provision does not apply to employment tests that require the use of sensory, manual, or speaking skills where the tests are intended to measure those skills....
-
Prevention of fraud in purchase of accessible seating. (Section-by-Section Analysis)
Such measures also must not impose burdensome requirements upon, nor restrict the rights of, individuals with disabilities....
-
11B-604.8.1.2 Doors
404 except that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured...
-
About this Study
These three criteria have not been defined adequately for measurement on any specific surface. Therefore, we’re required to make this evaluation subjectively....
-
Prevention of fraud in purchase of accessible seating. (Section-by-Section Analysis)
Such measures also must not impose burdensome requirements upon, nor restrict the rights of, individuals with disabilities....
-
11B-604.8.1.2 Doors
404 except that if the approach is from the push side of the compartment door, clearance between the door side of the compartment and any obstruction shall be 48 inches (1219 mm) minimum measured...
-
Ampetronic CLD1AC Compact Small Area & Counter Induction Loop Driver Hearing System
Measuring only 180 x 74 x 35mm and with an output current of 2.4A RMS, the CLD1AC is the smallest and highest performance amplifier in it’s class....
-
Federal Elevator Serenus LULA Elevator
steel control panel and trim Automatic 2 speed doors (36″ X 80″ OR 36″ X 84″ Prime Coat) 30 fpm. (0.15 m/s) maximum speed 25 ft. (7.6 metres) maximum travel (This measurement...
-
ADDENDUM TO PHASE I FINAL REPORT: Points of Clarification
Wheelchair measurements were completed without the person seated in their wheelchair. ...
-
Physical agility tests
For example: At the pre-offer stage, a police department may conduct an agility test to measure a candidate's ability to walk, run, jump, or lift in relation to specific job duties, but...
-
703.5.5 Character Height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
Issue: Self-Evaluation and Transition Plans
Remedial measures necessary to bring the programs, policies, and services into compliance with Title II should be specified — including, but not limited to: (1) relocation of programs to...
-
5. Edge Protection
Therefore, the final rule requires in M303.2.6 that platforms with wheelchair spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection, measured...
-
703.5.5 Character Height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
703.5.5 Character Height
Viewing distance shall be measured as the horizontal distance between the character and an obstruction preventing further approach towards the sign....
-
F. Impact on small entities
The Department seeks input regarding the impact the measures being contemplated by the Department with regard to Web accessibility will have on small entities if adopted by the Department...
-
National Network of ADA Centers
The height of the transfer surface during patient transfer shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum measured from the floor to the top of the transfer surface....
