Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent ramp run....
Search Results "Head End Wall"
Filters
Commonly Searched Documents
-
11B-505.10.1 Top and bottom extension at ramps
-
11B-605.2 Height and depth
Urinals shall be the stall-type or the wall-hung type with the rim 17 inches (432 mm) maximum above the finish floor or ground....
-
Do access aisle borders (in blue) have to be painted on all four sides to be considered compliant?
I would also say that both of the "end" lines would/could be within the required length. ...
-
410.6 Doors and Gates
End doors and gates shall provide a clear width 32 inches (815 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
11B-410.6 Doors and gates
End doors and gates shall provide a clear width 32 inches (813 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
2. REGULATORY BUILT-IN TOLERANCES
Building Code Section 1101B.5 indicates all dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end...
-
Handrail Extensions
Handrail Extensions ADAAG addresses handrail height, diameter, and extensions provided to the end of the gangway....
-
5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301)
The patient would not use the short end as the point of entry because it would require the patient to slide a long distance to lie on the stretcher....
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Parking spaces at the end of block face can be served by curb ramps or blended transitions at the pedestrian street crossing....
-
11B-605.2 Height and depth
Urinals shall be the stall-type or the wall-hung type with the rim 17 inches (432 mm) maximum above the finish floor or ground....
-
505.10.3 Bottom Extension at Stairs
Extension shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
4. Grab Bars
Does the toilet in each accessible guestroom bathroom have a horizontal grab bar along the adjacent side wall that is at least 42" long and mounted 33"-36" above the floor for stabilization...
-
G. Compartment Size
If the accessible toilet is in a stall, does the stall measure at least 60" wide and 56" deep if it is wall mounted or 59" deep if it is floor mounted to allow persons who use wheelchairs...
-
11. Door Maneuvering Clearance
(Note: this requires at least 18" of wall space on the latch side of the door.) [ADA Stds. 9.2.2(3); 4.13.6] Yes __ No __ N/A __ Comments: _____________________________________...
-
Section 1193.23 Product design, development and evaluation
At this end of the evaluation spectrum, only one hour of professional time is projected to be required, for an estimated cost of $80....
-
4.Information, documentation, and training
Such information and documentation includes user guides, installation guides for end-user installable devices, and product support communications, regarding both the product in general and...
-
206.7 Platform Lifts, F206.7 Platform Lifts
Amendatory Language For the reasons stated in the preamble, we amend 36 CFR part 1191 as follows: In 206.7, adding a new sentence at the end of the section to read as follows: 206.7...
-
3.6.2. Device Replacement
To account for the ongoing costs associated with the replacement of devices prior to the end of their lifespan and the replacement of these devices at the end of their lifespan, the primary...
-
Section 1194.41 Information, Documentation, and Support (Preamble, Section-by-Section Analysis)
Paragraph (a) states that when an agency provides end-user documentation to users of technology, the agency must ensure that the documentation is available upon request in alternate formats...
-
Collection of Information: Telecommunications Act Accessibility Guidelines; Annual Reporting Burden
method for obtaining information concerning the accessibility and compatibility description of the equipment, alternate formats and customer and technical support for the equipment; and (3) end-user...
-
Willoughby Industries WAW-2333 AquaWave® Three Station Solid Surface Lavatory System
The pre-assembled water distribution head and pedestal base shall be constructed of heavy gauge, type 304 stainless steel (the pedestal back plate is galvanized)....
-
Willoughby Industries WAW-2322 AquaWave® Two Station Solid Surface Lavatory System
The pre-assembled water distribution head and pedestal base shall be constructed of heavy gauge, type 304 stainless steel (the pedestal back plate is galvanized)....
-
Priority 2: Access to Goods & Services
Word Fillable Form (2.5MB) Word Non-Fillable Form (2.4MB) PDF Non-Fillable Form (1.4MB)
-
605.2 Height and Depth
Urinals shall be the stall-type or the wall-hung type with the rim 17 inches (430 mm) maximum above the finish floor or ground....
