Ramps not subject to the exception to 405.5 shall be designed to maintain a 36 inch (915 mm) minimum clear width when handrails are installed....
Search Results "Seat Width"
Filters
Commonly Searched Documents
-
11B-405.8 Handrails
-
Sec.36.308(a)(3)
(3) The requirements of paragraph (a) of this section shall not be interpreted to exceed the standards for alterations in subpart D of this part.
-
TOTO® Drake Two-Piece Toilet, 1.6 GPF, Elongated Bowl
• G-Max® fl ushing system, low consumption (1.6GPF/6.0LPF) • Universal Height • Two-piece design with high-profi le tank • Elongated front bowl and tank set, less seat...
-
Delta Toilet with FlushIQ Round Front C41903T-WH
electronics and mechanical parts Features ADA compliant chair height bowl to make sitting down and standing up easier 2 in. fully glazed trap-way Round-front bowl with slow-close seat...
-
Highest and Lowest Heights Obtained
The 5th percentile lowest and highest transfers attained were similar to the average WMD seat height (22.1 inch) for all protocols....
-
11B-604.8.1.1 Size
When deployed the baby changing tables shall not obstruct the required width of the accessible route except as allowed by Section 11B-307.2....
-
Features of Accessible Parking Spaces
If the accessible route is located in front of the parking space, install wheel stops to keep vehicles from reducing the clear width of the accessible route below 36 inches. 3....
-
Addendum G: Comparison of Transfer Abilities between Men and Women
The average wheelchair seat to floor height for men was 22.2 (±1.44) inches and the average height for women was 21.65 (±1.31) inches....
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
2. a. iv. Path-of-Travel (wheelchair) space allowances
Clear ground space width Maximum doorway depth and passage width Turning space: C1. Accessible route turns around an obstruction: C2....
-
G. Chapter 6: Wheelchair Spaces and Securement Systems
Chapter 6 in the 2016 Non-Rail Vehicle Guidelines establishes technical requirements for wheelchair spaces, wheelchair securement systems, and seat belts and shoulder belts provided for...
-
Gates and Barriers
That section requires 36 inches (915 millimeters) of clear width....
-
Spy City Café
The Café has no accessible seating. Where fixed tables are provided at least 5% but not less than one of the fixed tables shall be accessible. See Standards § 5.1....
-
Ramp Requirements [§405]
Ramp Requirements [§405]
-
§ 38.75(c)
(c) Characters on signs required by paragraphs (a) or (b) of this section shall have a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10,...
-
M303.2.3.1 Front or Rear Entry
Where wheelchair space entry and exit is provided at only one end (front or rear) the wheelchair space shall be 48 inches (1220 mm) deep minimum.
-
ABA CHAPTER 9: BUILT-IN ELEMENTS
[See subsections ...]
-
M303.2.3.3 Side Entry
Where wheelchair space entry is only from the side, the wheelchair space shall be 60 inches (1525 mm) deep minimum.
-
M303.2.3.2 Pass Through Entry
Where wheelchair space entry and exit permits pass through from one end to the other, the wheelchair space shall be 40 inches deep (1015 mm) minimum.
-
Chapter 9: Built-In Elements
Chapter 9 covers built-in elements, including dining surfaces and work surfaces (902), benches (903), and sales and service counters (904). Changes made to this section...
-
CHAPTER 9: BUILT-IN ELEMENTS
CHAPTER 9: BUILT-IN ELEMENTS
-
DIVISION 9: BUILT-IN ELEMENTS
[See subsections ...]
