Section 104.34 prescribes standards for educating handicapped persons with nonhandicapped persons to the maximum extent appropriate to the needs of the handicapped person in question....
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
24. Educational setting
-
205 Operable Parts, F205 Operable Parts
Exception 9 clarifies that operable parts in these units are not required to comply with the technical requirements for operable parts....
-
Title II Program Accessibility
When structural changes are made to existing pools, including installation of a fixed pool lift, the changes must comply with the 2010 Standards....
-
‘‘Facility.’’ (Preamble, Section-by-Section Analysis)
personal property, including the site where the building, property, structure, or equipment is located....
-
Facility (Section-By-Section Analysis and Response to Comments)
personal property, including the site where the building, property, structure, or equipment is located....
-
11B-203.10 Raised refereeing, judging, and scoring areas
Raised structures used solely for refereeing, judging, or scoring a sport shall not be required to comply with these requirements or to be on an accessible route....
-
11B-203.10 Raised refereeing, judging, and scoring areas
Raised structures used solely for refereeing, judging, or scoring a sport shall not be required to comply with these requirements or to be on an accessible route....
-
A. Accessible Voting Program
If Harris County asserts, and the United States agrees, that remediation and relocation to an accessible polling place location are infeasible, then Harris County shall comply with Title...
-
810.5.3 Platform and Vehicle Floor Coordination
In light rail, commuter rail, and intercity rail systems subject to Department of Transportation regulation 49 CFR 37.21 where it is not operationally or structurally feasible to meet the...
-
4.3.8 Operating forces
This should include: • Identifying maximum operating force requirements based on the types of grips and forces exerted....
-
Camping and Picnic Facilities and Viewing Areas on Trails [F247.4]
of whether the trail complies with the technical requirements for trails....
-
Proposed Section 36.309 Purchase of Furniture and Equipment (Preamble, Section-by-Section Analysis)
Equipment Section 36.309 of the proposed rule would have required that newly purchased furniture or equipment made available for use at a place of public accommodation be accessible, to the extent...
-
Use Zone
The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 (incorporated by reference, see “Referenced Standards” in Chapter...
-
Location [§208.3]
A maximum travel distance is not specified in the Standards....
-
Ground Level Play Components: ADA Standard Section 240.2.1
Section 240.2.1 covers scoping requirements in the current ADA Standards for ground level play components.
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
§1607.5 General standards for validity studies.
If job progression structures are so established that employees will probably, within a reasonable period of time and in a majority of cases, progress to a higher level, it may be considered...
-
Fur out the wall
The centerline of the water closet shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (430...
-
Nosings: ADA Standard Section 504.5
Section 504.5 covers the current ADA Standards for stair nosings.
-
11B-705.1.1.1 Dome size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (22.9 mm) minimum and 0.92 inch (23.4 mm) maximum, a top diameter of 0.45 inch (11.4 mm) minimum and...
-
11B-705.1.1.1 Dome size
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (22.9 mm) minimum and 0.92 inch (23.4 mm) maximum, a top diameter of 0.45 inch (11.4 mm) minimum and...
-
11B-610.3 Shower compartment seats
The top of the seat shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....