Amendments Act’s purpose of reinstating a broad scope of protection under the ADA, the definition of ‘‘disability’’ in this part shall be construed broadly in favor of expansive coverage to the maximum...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
Filters
Commonly Searched Documents
-
§ 35.101 Purpose and broad coverage
-
Water Flow: ADA Standard Section 602.6
Section 602.6 covers the current ADA Standards for the drinking fountain water flow.
-
Camping and Picnic Facilities and Viewing Areas on Trails [F247.4]
of whether the trail complies with the technical requirements for trails....
-
Transit Stops (R308.1) (Section-by-Section Analysis)
The grade of the boarding and alighting area parallel to the street or highway must be equal to street or highway grade to the extent practicable....
-
Counter: ADA Standard Section 904.3.2
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
11B-809.10.8.7 Mirrors and towel bars
Where mirrors are provided the bottom edge of the reflective surface shall be 40 inches (1016 mm) maximum above the finish floor....
-
Sec.36.405(b)
(b) If it is determined under the procedures set out in section 4.1.7 of appendix A that it is not feasible to provide physical access to an historic property that is a place of public accommodation...
-
GANGWAY
[DSA-AC] A variable-sloped pedestrian walkway that links a fixed structure or land with a floating structure. Gangways that connect to vessels are not addressed by this code....
-
§40.1 Purpose.
This part prescribes standards for the design, construction, and alteration of publicly owned residential structures to insure that physically handicapped persons will have ready access...
-
FACILITY
All or any portion of a building, structure, or area, including the site on which such building, structure or area is located, wherein specific services are provided or activities performed...
-
Height: ADA Standard Section 804.3.2
The kitchen work surface shall be 34 inches (865 mm) maximum above the finish floor or ground....
-
11B-703.5.7 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADA Standards] 703.5.7 Stroke Thickness....
-
11B-804.3.2 Height
The kitchen work surface shall be 34 inches (864 mm) maximum above the finish floor or ground....
-
Elevated Play Component
Elevated Play Components An elevated play component is a play component that is approached above or below grade and is part of a composite play structure. ...
-
III-4.4100 General
What is a communication barrier that is structural in nature?...
-
B.6.iii. - Is undue burden the only grounds for acquiring EIT that does not meet the applicable technical provisions?
No. There are several exceptions to the requirements of Section 508 (see section G).
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
Consequently, the maximum ramp slopes specified in the existing guidelines, while fairly steep for some types of deployments (such as 1:4 to the roadway), reflect what was feasible given...
-
Facility
Facility – all or any portion of buildings, structures, sites, complexes, rolling stock or other conveyances, equipment, roads, walks, passageways, parking lots, or other real or personal...
-
101.2 Scope
shall apply to the construction, alteration, movement, enlargement, replacement, re- pair, equipment, use and occupancy, location, maintenance, removal and demolition of every building or structure...
-
11B-602.6 Water flow
The spout shall provide a flow of water 4 inches (102 mm) high minimum and shall be located 5 inches (127 mm) maximum from the front of the unit....
-
Special Holding Cells and Special Housing Cells: ADA Standard Section 232.3
Section 232.3 covers scoping requirements in the current ADA Standards for special holding cells and special housing cells.
-
Dome Size: ADA Standard Section 705.1.1
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...
-
§40.2(b)(4)
(4) Nonresidential structures appurtenant to a residential structure covered under this part. [36 FR 24437, Dec. 22, 1971, as amended at 49 FR 31620, Aug. 7, 1984]...