Because a mix of public and private facilities are used as polling places, public entities may ensure Election Day accessibility of a polling place by using low-cost temporary measures,...
Search Results "Mitigating Measures"
-
POLLING PLACE ACCESSIBILITY IS REQUIRED BY THE AMERICANS WITH DISABILITIES ACT
-
Introduction
Dimension definitions and measurement techniques vary from study to study and, in many cases, samples were very small....
-
§1607.16 Definitions.
Demonstrated by data showing that the selection procedure measures the degree to which candidates have identifiable characteristics which have been determined to be important for successful...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
In order to mitigate existing barriers, it is first necessary to identify them....
- Handbook of Construction Tolerances by David Kent Ballast FAIA, CSI
- Just Manufacturing Deck Mounted Classroom Faucet with Vandal Resistant Lever Handle
- AJW Architectural Products U109 16 oz. Plastic Bulb Liquid Soap Dispenser - Surface Mounted
- Just Manufacturing Classroom Concealed Ledgemount Single Handle Restricted Swing Faucet
- Better Living LINEA Luxury Soap Dispenser
- Precision Safe Sidewalks LLC Sidewalk Trip Hazard Repair Service
- M-D Building Products, Inc. GEN2 SmartTool™ Digital Level
- Corada Product Certification Process
-
Accessible Product Certification Process
Manufacturers are given a time frame in which to implement corrective measures....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
Companion Seats
Consistent with the ANSI A117.1‒2003 standard, the provision in the final rule specifies that shoulder alignment is to be measured 36 inches from the front of the wheelchair space and that...
-
Building Entrance
(See Part 2 of this document for tips on taking measurements.)...
-
M301.2.1 Adjustability (Section-by-Section Analysis)
; (3) at least four additional transfer heights located between the low and high transfer heights, separated by one inch minimum increments; and (4) the transfer surface height will be measured...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
604.3.2 Overlap
complying with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1675 mm) minimum measured...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
505.4 Height
A maximum height of 28 inches (710 mm) measured to the top of the gripping surface from the ramp surface or stair nosing is recommended for handrails designed for children....