more than 3 degrees (exclusive of vehicle roll or pitch) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
Search Results "Approved Testing Agency"
-
§ 38.23(b)(9) Platform deflection
-
§ 38.125(b)(9) Platform deflection
not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded with 600 pounds applied through a 26 inch by 26 inch test...
-
Automated Announcement Systems
APTA and a statewide association of transit managers noted their general approval for this proposal....
- Bobrick TrimLine Series ADA Surface-Mounted Hand Dryer B-7120.230V
- SSB Bart Group
-
E. Paperwork Reduction Act
Paperwork Reduction Act Under the Paperwork Reduction Act (PRA), agencies are prohibited from conducting or sponsoring a “collection of information” as defined by the PRA unless in advance...
-
E202.6.2 Required Documentation
The responsible agency official shall document in writing the basis for determining that conformance to requirements in the Revised 508 Standards constitute an undue burden on the agency...
- Corbin Russwin Inc. FE6800 Fortified Multi-Point Latching System
- Guidance for Conducting Physical Functional Assessments for ADA Paratransit Eligibility
-
§8.57(b) Noncompliance with §8.50
Department is not required to provide assistance during the pendency of the administrative proceeding under such paragraph (c), except where the assistance is due and payable under a contract approved...
-
C102.1 Incorporation by Reference
The Director of the Office of Federal Register has approved the standards for incorporation by reference in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51....
-
E102.1 Incorporation by Reference
The Director of the Office of the Federal Register has approved the standards for incorporation by reference in accordance with 5 U.S.C. 552(a) and 1 CFR Part 51....
-
711.4.2 Membrane penetrations
Such penetrations shall not exceed an aggregate area of 100 square inches (64 500 mm2) in any 100 square feet (9.3 m2) of ceiling area in assemblies tested without penetrations....
-
Treatment of Data
Through further analysis, results of playground surface tests for firmness and stability were compared within surface categories and across surface categories to determine the mean, range...
-
Suggestion by Eldon Tipping
Tipping suggested that each ramp should be evaluated independently as a Random - Traffic Test Surface....
-
Acceptable SEWF Systems
Preliminary portable impact tests provided an indication of the cushioning performance of the stabilizing binder....
-
Appendix C Rotational Penetrometer Data Form
Beneficial Designs Serial num-ber: BDRP- Date of last calibration: Tire pressure set at 36 psi on (date): By: Date & Test...
-
Selection of Locations
The 11 test plots were installed in a previously undisturbed wetlands area where the maximum running slope of any of the sections was 7.6 percent....
-
APPENDIX A
The site plan will be labeled with locations 1‒9 to identify the critical test areas. One copy will be kept on file with NCA. ...
- American Standard Jocelyn 1-Handle Kitchen Faucet 9316.000
- University of Michigan Transportation Research Institute
-
Discover Excellence at the Best Dental Clinic Dubai
High-quality materials and internationally approved practices ensure reliable and lasting results....
-
1630.15(b)(1)
It may be a defense to a charge of discrimination, as described in section 1630.10, that an alleged application of qualification standards, tests, or selection criteria that screens out...
-
§382.133(f)(2)
(2) Any applicable requirement for a manufacturer-affixed label to reflect that the device has been tested to meet requirements for medical portable electronic devices set by the FAA for...
